Stanley Omnilock
a Product Group of Stanley Security Solutions, Inc.
1
Planning the installation
T83312/Rev A 000000 ER-7991-12 Jan 2010
Contents
These installation instructions describe how to install
your 45HOM Mortise Lock. Topics covered include:
Planning the installation...
........................................1
Preparing the door and door jamb
..........................4
Installing the lock
........................................................7
Completing the installation
......................................9
Site survey
Use the following survey to record information
about the installation site. You need this information
to determine how to prepare the door for the lock.
Door information
Door handing and bevel:
If a handing change is required, see “Rotate latchbolt
(if necessary)” on page 4.
❐
Left hand (LH)
❐
Left hand, reverse bevel (LHRB)
❐
Right hand (RH)
❐
Right hand, reverse bevel (RHRB)
Door thickness: 1-3/4 to 2 inches (44 to 50 mm).
Environment information
a. See Stanley installation instruction
Addendum (T83317)
Extreme Weatherized Installation
for the extreme weatherized
model installation.
Model
Side of
door
Temperature
Range
Exposure
Standard
Outside
+32°F to +129°F
0°C to +54°C
Drip proof.
Inadvertent
splashing of
water spray
acceptable.
Weatherized
Outside
-4°F to +129°F
-20°C to +54°C
Direct exposure
to rain and snow
Extreme
Weatherized
a
Outside
-40°F to +129°F
-40°C to + 54°C
Direct exposure
to rain and snow
Inside
+32°F to +129°F
0°C to +54°C
N/A
Installation Instructions for
Stanley Omnilock 45HOM
Mortise Locks
Components checklist
Use the following checklist to make sure that you
have the items necessary to install your Omnilock
Mortise Lock.
Components provided in the box:
❐
Inside and outside trim cassettes
❐
Inside and outside rose and rose ring
❐
Outside escutcheon assembly
❐
Mortise case assembly
❐
Mortise cylinder and collar
❐
Outside lever and spindle assembly
❐
Inside lever
❐
Strike package
❐
Installation template and instructions
❐
Screw package
❐
Mortise case faceplate
❐
Batteries
❐
Torx T15 driver
❐
1/8” hex wrench
Other components:
❐
Programming Default ID Card (provided with
software)
