Using the ACC-2018A Hypermetrics Dual-slot Card Carrier
|
1
P/N 71-008729 Rev A, August 2019
Using the ACC-2018A Hypermetrics
Dual-slot Card
Carrier
This document describes the procedure for installing and removing test modules that
require card carriers for use in the SPT-N12U, SPT-N11U, and SPT-N4U chassis.
The ACC-2018A Hypermetrics dual-slot card carrier accommodates dual-slot Large Form
Factor (LFF) Spirent TestCenter test modules for insertion into the SPT-N12U/SPT-N11U/
SPT-N4U chassis.
Note:
The ACC-2018A card carrier does not fit into any other Spirent TestCenter chassis.
Warning:
Never remove (or insert) the test module from the card carrier while the carrier
is installed in the chassis – damage may occur. You must remove the card carrier from the
chassis before performing these tasks.
Installing Test Modules
You use the same procedure for installing test modules in either chassis. Refer to the
following:
•
“Installing Test Modules in the SPT-N12U, SPT-N11U, and SPT-N4U”
!
•
Use proper ESD procedures when handling the test module. Refer to the
ESD
Requirements
appendix
in
Getting Started with
Spirent TestCenter
for detailed
information on these procedures.
Installing Test Modules in the SPT-N12U, SPT-N11U, and SPT-N4U
The SPT-N12U, SPT-N11U, and SPT-N4U chassis are Next Generation Form Factor
(NGFF) chassis. To install previous generation Large Form Factor modules, each module
must first be installed in an NGFF Card Carrier.
•
Dual-slot cards require the ACC-2018A card carrier
•
Single-slot modules require the ACC-2017A card carrier
Refer to the instruction document titled
Using the ACC-2017A Hypermetrics Single-
slot Card Carrier.
Summary of Contents for ACC-2018A
Page 6: ......
