Skytech: TM-R-2A
REV. 10-12-18 Page 1
Model:
TM-R-2A
INSTALLATION AND OPERATING INSTRUCTIONS
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE
INTRODUCTION
This SKYTECH remote Wireless Wall Timer system was developed to provide safe, reliable, and user-friendly remote
control system for gas heating appliances. This dry contact system can be operated manually from the transmitter. The
system operates on one of 65,536 security codes that are programmed into the transmitter at the factory.
WALL TIMER
Indicator
Light
30 MIN
60 MIN
120 MIN
OFF
The wall timer operates on a (2) 3V button cell batteries (included) made
specifically for remote controls and electronic lighters. Before using the wall
transmitter, install the two (2) 3V button cell batteries. Follow the instructions below.
The wall timer has a 30 min, 60 min, 120 min, and OFF buttons. When any buttons
on the wall timer are pressed, a signal light on the wall timer illuminates briefly to
verify a signal has been sent. If the signal light does not illuminate, check the
batteries. Upon initial use, there may be a delay of five seconds before the remote
receiver will respond to the wall timer.
TO INSTALL BATTERIES
1. Remove face from backing plate by insetting a small
screwdriver into the small slot
at the top or bottom of the faceplate as shown below then snap OFF.
2. Locate the (2) holders for the 3V button cell batteries.
3. Place the button cell batteries into the battery holders and snap into place.
(Make sure that the batteries are installed with the (+) plus side as shown to the right.
4. After the batteries are installed replace the faceplate on the base
.
30
60
120
OFF
Insert small screwdriver
into slot at the top and
sides to pop cover off
TO REMOVE THE BATTERIES
1.Remove face from backing plate by insetting a small screwdriver into the small slot
on the side at the top or bottom of the faceplate as shown to the right then snap OFF.
2.Locate the (2) holders for the 3V button cell batteries.
3.Insert a small screwdriver into the slot at the button cell battery and pop the
battery out (Slots shown in picture above).
4.After the batteries are installed replace the faceplate.
+
Plus
Side
+
Plus
Side
Insert small screwdriver
into slot and pop out
batteries from holder
Insert batteries
under tabs; snap
into holder
30 MIN
60 MIN
120 MIN
OFF
CALIFORNIA PROPOSITION 65
WARNING
This product can expose you to Tetrabromobisphenol-A,
which is known to the state of California to cause cancer.
(For more information, go to www.p65warnings.ca.gov)
