![background image](http://html1.mh-extra.com/html/signature-solar/eg4/eg4_user-manual_1269044001.webp)
EG4 High Frequency Intelligent Charger
User Manual
Thank you for your purchase of an EG4 Battery Charger from Signature Solar. Welcome to the EG4 battery family.
This manual contains information about how to install, operate, and care for your new charger. If this is your first time
purchasing from Signature Solar, this manual can instruct you on how to properly use and care for your new battery
charger. Please read this manual prior to installing or using your new EG4 Battery Charger.
Quick Features
●
Up To 95% Efficiency
●
Waterproof Design
●
Shock Resistant for Storage and Operation (Can be used in mobile operations such as RV’s, Motorhomes,
etc.)
Protection Features
The EG4 Battery Charger comes loaded with multiple protection features which allow you peace of mind while using.
It constantly monitors the output and will shut down operation if it detects any of the following issues:
●
Output Over Voltage Protection
●
Output Over Current Protection
●
Output Short Circuit Protection
●
Reverse Polarity Protection
●
Charger Over Temperature Protection
●
Ambient Temperature Protection
Installation Environment
The location for installing and using the battery charger is important to ensure that the charger operates normally and
to avoid situations where there may be damage to the charger or the battery it is connected to.
The EG4 Battery Charger has built in intelligent temperature protection which operates in two aspects. The first is
stopping the charge function when the battery or unit is too hot. It is best to place the charger in the same location so
it can use it’s ambient temperature sensor to ensure it is not charging while the temperature is not appropriate for the
battery. The second is to achieve the best charging current according to the environmental temperature by adjusting
the charging voltage. For these reasons, it is highly recommended that the installation of the charger is close to the
battery it is charging.
It is also important that the heatsink fins of the charger are not blocked, to allow any heat produced by the charger to
escape. Please place the charger in a location where there is adequate airflow to prevent overheating, dust
accumulation, and in a location where there is no chance of flammable substances coming into contact with the
charger.
Lastly, although the charger is designed to be water resistant, it should not be installed in a location that would
frequently be exposed to water. The water resistant design is to ensure safe operations in the event that water is
splashed onto or around the charger. It is not designed to be consistently submerged or exposed to water during
operations.
Installation Instructions
Once you have a suitable location for the EG4 Battery Charger to be installed, please adhere to the following
information to ensure proper operation of the charger.
●
The charger power supply is a standard three port plug that includes a grounding pin. Please ensure the
plug is connected to a ground for safety reasons.
●
If you are connecting this charger to an extension cord, please verify that the extension cord can bear the
charger maximum input current. An undersized cord can cause the charger to not operate properly, and may
cause damage.
●
If using the charger mounting plate, it is required that it be fixed in a horizontal position. If used in a vehicle,
the mounting plate should be horizontal when compared to the vehicle, and mounted in a location where it
will be safe.
●
The charger requires 10cm of space in all directions other than the mounting location to ensure proper
ventilation.