Installation Instructions
Document No. 129-262
September 30, 2009
ASK76.1U Conduit Adapter
Item Number 129-262, Rev. BA
Page 1 of 2
Product Description
This kit provides an adapter that allows for a conduit
connection to the OpenAir™ GDE/GLB models.
Contents
This kit contains one conduit adapter and a flat head
screw.
Product Numbers
ASK76.1U
Required Tools
•
Flat head screw driver
•
4 mm hex wrench
Expected Installation Time
10 minutes
Installation Conventions
WARNING
Personal injury/loss of life may
occur if you do not follow a
procedure as specified.
CAUTION
Equipment damage or loss of
data may occur if you do not
follow a procedure as specified.
Prerequisites
Provide a conduit connector.
Installation
Loosen and remove the stop set screw and nut from the
actuator.
See
Figure 1
Figure 1.
Attach the desired conduit connector to the base of the
conduit adapter.
NOTE
: A second opening in the base of the
adapter is available by removing the
knock-out.
Figure 2.
Thread the cable through the opening(s) in the conduit
adapter.
Set the actuator in the adapter so that the actuator
fits into the guide on the adapter.
