instructions for
Aluminium torch 10w t6 cree led
AdjustAble focus 2 x d cell
model no:
led447
thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. sAfety
1.1.
General
8
do not
shine directly into your, another person’s or an animal’s eyes.
8
do not
allow children to use the torch.
8
do not
use the torch if you suspect that the battery or the torch casing is damaged.
8
do not
leave batteries in a discharged state. Before storage remove batteries and dispose of in the correct manor.
1.2.
battery safety
wArninG!
To reduce the risk of burns or fire:
8
do not
attempt to open the batteries.
8
do not
crush, puncture, short contacts or dispose of in fire or water.
8
do not
expose to temperatures above 60°c (140°).
replace only with the batteries designed for this product.
recycle or dispose of used batteries as stipulated by local regulation.
if the electrolyte in the batteries gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with
cool water and seek immediate medical attention.
2. introduction
single 10W t6 cree led produces extremely bright, white light with an output of 680lumens and a working range up to 200 metres. focus
type can be changed from spotlight to wide area by twist/slide action of the head. lightweight aluminium housing. two function on/off push
button for full and 30% energy saving mode. Powered by 2xd batteries.(batteries not included)
3. specificAtion
model no
: .................................................................
led447
led: ................................................................10W t6 cree
lumen out (high/low): ........................................680lm/200lm
Battery .................................................... 2 x d (not included)
Working range: ..........................................................200mtr
led447 | issue 1 27/05/16
Original Language Version
© Jack sealey limited
refer to
instructions
on/mode change/off
Button
Battery compartment
screw cap
twist/slide head
fig.1
