4 DRAWER & CUPBOARD 1210MM MOBILE
WORKSTATION
MODEL NO:
AP47PWS
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
AP47PWS Issue 1 11/03/2020
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing
1. SAFETY
9
Only use on firm, level, unobstructed surfaces which are capable of supporting the trolley.
8
DO NOT
overload.
9
Apply the brakes when stationary.
8
DO NOT
stand/ride on the trolley, climb on open drawers or allow others to do so.
9
Replace or repair damaged parts. Use only recommended parts. Unauthorised parts may be dangerous and will invalidate the warranty.
9
Two persons maybe required to assemble the unit.
WARNING!
The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which cannot be built into this product, but
must be applied by the operator.
2. INTRODUCTION
Durable mobile workstation with four drawers and cupboard. Sheet metal drawers with structural foam fronts run on ball bearing drawer slide.
Recessed side and rear panels allow for storage baskets to be fitted where necessary. Supplied with four storage baskets. Four heavy-duty
5” composite castors with rubber over mould, two fixed and two swivel with brake. Structural foam handle with tool storage for quick access to
frequently used tools. Cupboard door fitted with barrel lock and supplied with two keys.
3. SPECIFICATION
MODEL No: ........................................................... AP47PWS
O
verall Size (W x D x H):
....................
1210 x 700 x 1000mm
X
-Large Drawer (x4)(W x D x H):
............
120 x 370 x 480mm
C
upboard (W x D x H):
............................
610 x 410 x 490mm
4. CONTENTS
4.1.
Unpack all parts and check against parts diagram below.
4.2.
Tools required: 13mm A/F spanner, No. 2 Cross head screwdriver.
fig.1
