MIGHTY WOLF LOOM
TM
A
ssembly
I
nstructIons
Find out more at
schachtspindle.com
Schacht Spindle Company 6101 Ben Place Boulder, CO 80301
p. 303.442.3212 f. 303.447.9273
© 2018 Schacht Spindle Company, Inc.
12.18
4.
Continue holding onto the front and
rear beams and allow the loom to unfold
all the way. If there is a warp on the loom,
you may need to hold down the brake
release pedal with your foot to loosen the
warp as you unfold the loom.
UNFOLDING THE LOOM
1.
Remove all plastic wrap from the loom.
Remove both shipping braces by slightly
loosening the back beam knobs and
front beam screws holding them in place.
Discard the braces and tighten the knobs
and screws.
2.
Slightly loosen the black fold knobs
on each side of the loom (Figure 1).
Generally, a single turn will do.
Loosening the knobs all the way or
removing them can cause the loom to
collapse, which could result in injury.
3.
Stand at the side of the loom. Hold the
front and rear beams together slightly. Pull
the slide lock bars out toward the back of
the loom.
BEFORE YOU BEGIN
■
All Wolf looms assemble in a similar way. Watch the Baby Wolf assembly video on our
Youtube channel (www.youtube.com/user/schachtspindle).
■
You’ll find a complete labelled diagram of the Wolf loom in your Maintenance and
Warranty manual and at schachtspindle.com.
■
Wolf loom legs are called out by where they cross each other. The legs that touch the
ground at the front of the loom are called “inside” legs because they are covered by the
“outside” legs when they cross at the loom center.
■
The beater is at the front of the loom. The brake is on the right side of loom.
FIGURE 1: UNFOLDING THE LOOM
slot in
castle
FRONT OF
LOOM
slide lock bar
shipping brace
front beam
screw
fold knob
back beam
knob
FL3002
FL3004
FL3012
FL3014
FL3022
FL3024
1X 3/8" cap nut for warp beam crank
handle
1X 3/8" washer for warp beam crank
handle
3X extra 8/32" hex nuts for shafts
Maintenance and Warranty Manual
4-shaft looms:
800X heddles
24X tie-up cords
8-shaft and 4 Now-4 Later looms:
1000X heddles
80X tie-up cords
PARTS
Wrapped onto warp beam:
3X apron bars
2X lease sticks (with holes)
2X additional 37" dowels (cherry looms
only)
Accessory pack:
1X brass reed hook
1X warp beam crank handle
14X 29" apron cords (or 2X 30-foot apron
cords for cherry looms only)
