Instruction leaflet
Sight 3 in 1
72644
www.saxbylighting.com
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Safety information
Cleaning Information
Saxby Lighting. BH23 3PE
• We recommend cleaning with a soft dry cloth or wash
with warm water or just use a damp cloth.
• Do not use abrasive materials as these will damage the
finish.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
The LED module is protected by a shade. The shade cannot be replaced, if the shade becomes
cracked or damaged, this light fitting must be discarded
Iss 2 06072017
• If after routine operation check, the lamp does not remain
lit for the three hour period, a new battery pack may be
required.
• Switch off the electricity at the mains, allow batteries to
fully discharge then reconnect to supply and allow to
charge for 24 hours.
• Test again for two hours, if light does not remain lit
change the battery pack as follows:
• Undo the screw on the side of the product and lift cover
off. Set screw aside for refitting later.
• Unplug the battery lead coming from the PCB. Remove
any cable ties around the cables.
• Remove the battery pack. Waste electrical products
should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local
authority or retailer for recycling advice.
•
Replace the battery with a 3.6V 800mAh Ni-Cd
ONLY.
Use of a different type of battery will damage the
product.
• Write current date on the new battery pack.
• Fit the new battery pack in position and plug battery pack
into the PCB.
• Refit the cover with the screw set aside earlier.
• Perform full operation check and update test record.
• Restore power and allow to charge for 24 hours.
Battery Replacement
• The LED Module in this product is non-replaceable.
Fitting/replacing bulbs
