background image

1

2

3

4

5

When using one EIDE cable 

 

Connect the cable to the SL (Slave) of the Master/Slave Select Terminal at the rear  

 

    of the DVD Writer. 

When using two EIDE cable

 

Connect the cable to the MA (Master) of the Master/Slave Select Terminal at the rear  

    of the DVD Writer. 

- If there is only one Optical drive: select MA (Master).

Hard Drive

Slave Drive (Choose the SL Jumper)

MainBoard

Hard Drive

Master Drive (Choose the MA Jumper)

MainBoard

SEC 1

PRI 1

-If there is two Optical drive, select MA (Master) / SL (Slave).

SEC 1

PRI 1

Hard Drive

Master Drive (Choose the MA Jumper)

Slave Drive (Choose the SL Jumper)

MainBoard

 (Choose the MA Jumper)  (Choose the SL Jumper)

LED

Eject Button

Door Tray

Emergency hole

If the compartment does not open 

when you press the Eject button, 

power off the computer, insert a pin 

or unfolded paper clip in the hole  

and push firmlhy)

Front

Rear

Interface Port

Master/slave select Port

Power Port

 Introduction

 

 Design and specifications are subject to change without prior notice.

Connecting the Cables to the  

 

DVD Writer

Connecting the Cables 

Connecting the power cable

 

The 4-pin power cable from the internal power unit of your computer must    

   be connected to the power terminal the rear of the DVD Writer.

1

Installing a jumper on the master/slave select terminal

 

Connect a jumper to the rear side of the DVD Writer.

    If the jumper is connected to MA (Master), it will work in the Master mode.  

 

    If the jumper is connected to SL (Slave), it will work in the Slave mode.   

 

    If the jumper is connected to CS (CSEL), you can control the device by using the   
    host interface signal CSEL. (In general, connection to MA is recommended.)

2

Connecting the EIDE cable

 

Insert the EIDE cable, which is connected to the hard  

 

 

 

   disk to the interface terminal.

     (Place the red line of the cable close to the Pin 1.)

3

Power cable

 EIDE cable

Master/slave select terminal

CS : Cable Select(CSEL)
SL : Slave
MA: Master

6

7

Installing the Drive

Installing the DVD Writer

If necessary, attach a horizontal bracket to 

both sides of the drive.

• You can purchase these accessories separately  
   from your computer dealer.

  (Screws for use: M3 X 6 X 4)

1

Remove the plate from a free expansion slot and install the 

DVD Writer, as shown in the illustration.

• If you have no free expansion slot, install the drive in place of the  

 

 

  diskette drive.
• Make sure to use the standardized screws supplied (M3X6).

  - To use screws other than M3X6 may result in malfunction.

2

How to install the DVD Writer on your PC. First, remove the cover; 
connect the cable to the DVD Writer and then to the PC.

DVD 

Writer

Horizontal 

Bracket

Plate

Using the Drive/Storing and 
Cleaning Your Discs

Push the power button and boot the computer.

1

After booting the computer, open the disc  

 

compartment by pressing the Eject button.

2

Insert the disc (CD) with the label on the disc 

facing upwards and close the disc compartment 

by pressing the Eject button. The indicator light 

comes on.

3

Play the disc (CD).

4

Using the DVD Writer

 

Do not touch the surface  

    of a disc; hold it by the  
   edges.

 

To clean a disc, polish lightly  

 

     from the inside of the disc to the  
     outside with a soft cotton cloth.

 

Do not place a disc in direct sunlight.

 

Store a disc vertically in a well-ventilated and  

 

   stable location.

 

Do not write or attach a label on a disc.

 

Do not drop a disc or place heavy objects on it.

Storing Your Discs

Cleaning Your Discs

 

Run the CD player program supplied with the sound card or play the  

 

   Windows Media Player.

Playing CD-DA/Audio CDs

•  Follow the instructions provided with the disc.
•  A video card or MPEG software and a sound card need to be installed to view video CDs.  

Playing Video CDs

 

The disc may not function properly if there are fingerprints, foreign substances or   

   dust on the disc surface.

•  If the drive is vertically installed, you cannot use an 8 cm Mini Disc  

 

 

   because the disc is movable. 

8

9

Solving Technical Problems

System Requirements

Super- DVD Writer
SH-S222L(TS-H662L)

User Guide - ENGLISH

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause harmful interference 
to radio communications. However, there is no guarantee that interference will not 
occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be deter-mined by turning the equipment off 
and on, the user is encouraged to try to correct the interference by one or more of the 
following measures:

  • Re-orient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to
    which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

   

CAUTION

 Change or modifications not expressly approved by the manufacturer responsible for

 compliance could void the user ’s authority to operate the equipment.

 

LASER STANDARD

 IEC 60825-1 :1993 +A1 :1997 +A2 :2001

 

WEEE

 

Correct Disposal of This Product (Waste Electrical &Electronic Equipment)

 (Applicable in the European Union and other European countries with separate collection systems)

- http://www.samsung-ODD.com
- http://www.samsung.com  

Technical Specifications

This marking shown on the product or its literature,indicates that it should not be disposed with
other household wastes at the end of its working life.To prevent possible harm to the
environment or human health from uncontrolled waste disposal,please separate this from other
types of wastes and recycle it responsibly to promote the sustainable reuse of material 
resources. 
Household users should contact either the retailer where they purchased this product,or their
local government office,for details of where and how they can take this item for environmentally
safe recycling.
Business users should contact their supplier and check the terms and conditions of the 
purchase contract. This product should not be mixed with other commercial wastes for 
disposal.

•  

Samsung Eco-mark

  The Samsung’s own Eco mark helps consumers to easily understand that
  Samsung develops eco-friendly products. This mark represents Samsung’s
  continuous effort to develop eco-friendly products.                   

•  RoHS 

 

      

(Restriction of the use of certain hazardous substances in electrical and electronic 
equipment). The RoHS, the environment regulation announced by European Union, 
restricts the use of lead, mercury, cadmium, hexavalent chromium, PBB, and PBDE in 
products put on the market in The European Union after July 1, 2006. 

Safety Precautions

The following are basic precautions to ensure user safety  
and reduce the risk of property damage.

 

Do not place the drive in    

   direct sunlight.

 

Avoid low- or high-temperature  

   environments. 

 

Avoid high-humidity environments.

Handle with caution to prevent  
damage from external shock.

Do not drop the drive, and 
protect it fromsevere shocks.

 

It can damage the drive or cause  

   it to malfunction.

Do not move the drive while in operation and  
do not attempt to open the disc tray byforce.   
Make sure to close all working programs before 
attempting to open the tray and always use the 
open/close button.

Do not insert a pin into the emergency 
opening while in operation.

Do not use cracked, distorted or 
damaged discs.

In particular, a disc with a crack on the  
inner tracks may break while in use.

 

Never allow food particles or  

   foreign substances to enter the  
   drive casing. 

 

To protect against the risk of  

   fire, do ot spill such liquids as  
   alcohol and benzene on the  
   drive.

Important to read and understand  

at all times

Do not disassemble

1.  

Check to see that the disc does not have a crack before use. If the disc has a crack (especially around the center hole), it is recommended 
that you make a copy immediately and use the copy instead. When a cracked disc is used continuously,the size of the crack is  likely to 
grow and it will eventually result in irreparable damage to the disc.

2.   Do not use low quality discs (i.e., illegal products, scratched or damaged discs).

• Any change or modification not expressly approved by designated qualified personnel could  

 

    void your authority to operate this device.

Warning/Caution

Warning:

 

To warn the user that failure to comply with the instructions may result in  

 

 

 

serious injury or death.

Caution:

 To caution the user that failure to comply with the instructions may result in  

 

 

 

damage to property.

 

To reduce the risk of damage,  

   electric shock, and fire.

Do not disassemble, attempt to 
repair or modify the device without 
express approval as directed in the 
manual. 

Place the drive on a level 
surface.

 

Failure to do so may cause the  

   device to fall onto a hard surface,  
   resulting in damage or malfunction.

• 

  

If the power cable is not connected 

properly, it may cause a fire or 

damage the drive. Check the 

direction of the power connector and 

the drive incline before connection.

 

+5V DC 

  Ground

Ground 

+12V DC

When you install the drive

While operating

Other

Note) The maximum speed depends on the writing media condition 

            or some of user's PC environment.

OS   :  Microsoft Windows 2000/XP/Vista
CPU :  Pentium4 2.0GHz or above
RAM :  256MB or above(Windows 2000/XP)

 

The friction noise generated during SPIN-UP and STOP is caused by the

   Automatic Ball Balancing System(ABS) and is not a malfunction.

The tray doesn't open.

  See if the PC on.

   Make sure the power cable within the PC is connected 

properly.

   If the tray still won't open with the power on, turn the power off 

and insert a pin(paper clip) into the emergency hole to open.

The tray doesn't close.

  Make sure the disc has been inserted properly.

The drive is not working properly.

   See if the drive is connected properly to the PC.

  See if the device drive program has been installed properly.

The Window OS can't detect the drive.

   See if the device drive program has been installed properly.

   Can be an OS problem. Try reinstalling the Windows OS 

program.

The system doesn't read the disc.

   See if the system detects the drive.

   Make sure you use the types of discs that are supported 

by the drive.

  See if the LED turns into green.

  Make sure you inserted the disc with the label facing up.

   Make sure you are using the right program for disc 

playback.

  See if the disc is clean.

  See if any congealing has occurred.

   Make sure the region code of the drive matches the disc 

number.

You can download the user manual and  the related informations of software at the web site of 

our customer support as below.

 

URL : http://www.samsung-ODD.com 

 - User Manual Download :  Support > Download center > Web User Manual or User Manual

 - TruDirect Manual : Information > Software Quick Manual

 - Recording Software : Information > Flash Manual > Recording Software

 - TruDirect Software Download : Support > Download Center > Software 

SH-S222L(TS-H662L)

DVD Writer 

Category

DISC

Usable Discs

DVD :  DVD-R, DVD-RW, DVD+R, DVD+RW, DVD-ROM, DVD-Video, 

DVD+R (Dual), DVD-R (Dual), LightScribe DVD±R,DVD-RAM.

CD :  CD-ROM, CD-R, CD-RW, CD-DA, CD+E(G) 
         CD-MIDI, CD-TEXT, CD-ROM XA, Mixed Mode CD CD-I, 
         CD-I Bridge (Photo-CD, Video-CD), Multisession CD 
         (Photo-CD, CD-EXTRA, Portforio), LightScribe CD-R.        

 Disc 

Diameter

4.72 Inch or 3.15 Inch (120mm or 80mm) 

PATA

DVD-ROM

CD-ROM

110ms (Random)

130ms (Random)

Data transfer 

rate(MAX)

Access time

(Random)

  Buffer Memory

Size (Width x Height x Length)

Weight

Drive Installation

Temperature
Humidity

Operating 
Environment

 Interface 

Port

Interface

Support

DVD+R 

DVD+RW 

DVD+R DUAL 

DVD-R DUAL 

DVD-R 

DVD-RW 

DVD-ROM(Single) 

DVD-ROM(Dual) 

DVD-RAM

CD-ROM 

CD-R 

US-RW

HS-RW 

CD-RW

Media Type  

Write  

Read

2MB

Horizontal / Vertical

41°F ~ 122°F (5°C ~ 45°C)

20% ~ 80% (RH)

5.34 X 1.65 X 6.69 Inch (148.2 X 42 X 170mm)

750g

66.6MB/s (UDMA4)

 

Burst Transfer Rate

CAV 22X

ZCLV 8X

CAV 16X

CAV 12X

CAV 22X

CLV 6X

      -

      -

PCAV 12X

      -

PCAV 48X

ZCLV 32X

CLV 10X

CLV 4X

CAV 16X

CAV 12X

CAV 12X

CAV 12X

CAV 16X

CAV 12X

CAV 16X

CAV 12X

PCAV 12X

CAV 48X

CAV 40X

CAV 40X

CAV 40X

CAV 40X

Disc Labeling Time

CD Media 

Best

  

Less than 3`30``  

Less than 28`

DVD Media 

Best 

 

Less than 3`30``  

Less than 30`

 Media Type   Setting  

Titles only 

The entire label area
 (including graphics)

Reviews: