Clear Start™ Sailing Watch Operation
ENGLISH INSTRUCTIONS
The Clear Start™ Sailing Watch is a waterproof watch, which features time of day, a countup
(from zero) timer, and a programmed countdown timer with alarm.
The countdown timer can be set to countdown to zero and countup again or to countdown to
zero and then repeat the programmed period. Once the countdown timer is running, the
RONSTAN (START/STOP), SYNC, and MODE buttons are the only ones that will have a function.
At any time a button is pressed that is going to have any function, the watch sounds a single
beep.
OPERATING INSTRUCTIONS:
TO SET THE TIME
1. Put the watch into time mode by pressing the “MODE” button. This can be recognised because above
the digits the display will show no icons relating to countdown. Also if in 12 hour mode the time will show
AM or PM either above or below the central colon.
2. Press the “CLEAR” button and hold it down for approximately 2 seconds until the hour display begins
to flash
3. Press the “PROG” (short for programme) button until the correct hour is shown. Make sure if you are
in the 12 hour clock that AM or PM is correct, or if you are in the 24 hour mode that you have the correct
hour.
NOTE
: a) Each time you press the button the time will advance 1 hour
b) Keeping the button pressed in for a couple of seconds will start fast scrolling through the hours.
4. To change from 12 hour to 24 hour setting press the “RONSTAN (START/STOP)” button at any time
the hours are still flashing.
5. Once the correct hour and 12/24 hr setting are set press “MODE”. This confirms the hours and starts
the minutes flashing ready for setting
6. Press the “PROG” button until the correct minute is shown.
7. Once the correct hours and minutes are set, press “CLEAR” button one more time and the time is set
and running. The display will also stop flashing.
