![background image](http://html.mh-extra.com/html/riotec/ls6300e/ls6300e_programming-quick-manual_1463729001.webp)
Programming Quick Guide
LS6300E/LS6320E/LS6320V
Installation
Make sure that the scanner has the correct cable to
plug into the PC as below described:
1.
USB cable connection: / PS2 cable connection:
(Please use correct cable for the interface)
Reset Configuration to Default
If you are unsure of the scanner configuration or have
scanned the incorrect codes, please read the “Default”
barcode. This will reset the scanner to its factory
default.
Default
2.
RS232 cable connection:
Please read above “Default” first, then, set the output
mode as RS232 (SERIAL).
★
If you want to switch to different interface, please
scan the correct configuration code (Output Mode,
right above), then, change the appropriate cable.
3.
Auto-sensing switch ON/OFF
LS6320E has one button to control auto-sensing
function. Press the auto-sensing button to switch it
ON/OFF (Shown on below photo) Default is ON.
OUTPUT MODE –
KEYBOARD / USB
OUTPUT MODE
- RS232 (SERIAL)
OUTPUT
MODE
SINGLE SCAN
SINGLE SCAN
NO TRIGGER
READING
MODE
LASER TIMEOUT
– 5 SECONDS
LASER TIMEOUT
– 2 SECONDS
CODE 11 DOUBLE
CHECK -ENABLE
CODE 11 DOUBLE
CHECK -DISABLE
DOUBLE
CHECK
CODE 39
DOUBLE
CHECK -ENABLE
CODE 39 DOUBLE
CHECK -DISABLE
CODE 93 DOUBLE
CHECK -ENABLE
CODE 93 DOUBLE
CHECK -DISABLE
CODE 128 DOUBLE
CHECK -ENABLE
CODE 128 DOUBLE
CHECK -DISABLE
I2OF5 DOUBLE
CHECK -ENABLE
I2OF5 DOUBLE
CHECK -DISABLE
DOUBLE
CHECK
ID2OF5 DOUBLE
CHECK -ENABLE
ID2OF5 DOUBLE
CHECK -DISABLE
CODABAR DOUBLE
CHECK -ENABLE
CODABAR DOUBLE
CHECK -DISABLE
UPC/EAN DOUBLE
CHECK -ENABLE
UPC/EAN DOUBLE
CHECK -DISABLE
REVERSE IMAGE
–ENABLE
IMAGE
REVERSE IMAGE
-DISABLE
SEND BAR CODE ID
-DISABLE
CODE ID
SEND BAR CODE
ID–AS A PREFIX
SEND BAR CODE ID
-RESET
SEND BAR CODE
ID –AS A SUFFIX