1
Quick Guide
-DC9250DP
1
H92P
Connect to micro USB port of OTG device
2
3
*
Before you use scanner, please switch to "C" for battery charge
for 3~4 hours.
*
Under “C mode”, you can raise/lower soft-keyboard easily.(For
USB HID only)
4
H92P Scan Holder is with Li-Ion battery inside. When in charging,
please use the original USB power adaptor of OTG device
(recommended). Through it, it charges both OTG device and H92P
internal battery at the same time. When in low battery (Red LED
flashing), please charge it immediately.
LED Indicator Information
Green LED OFF
Full charged (Charge mode)
Green LED ON
Charging (Charge mode)
Red LED Flashing
Low battery (Operation mode)
Attention: Under “Operation mode” please do not charging,
otherwise the OTG device's battery will be charging back to H92P’s
battery.
5
The touch sensor area is around the central area. (For both sides).
Please check the above drawing for your reference.
Installation
Before using scanner, please make sure that the OTG device is fully
charged.
1.
Under USB HID interface
** When plugged into OTG device, it will be recognized and begin
to scan the barcode.
2.
Under USB Serial interface
** Please install PL-2303 driver into your OTG device first. PL-2303
driver can be downloaded from Google Play
** Connect scanner to your OTG device, then, you can know which
serial port scanner connects to.
** The data you scan will be sent to serial port and your APP can
get the data from serial port directly.
Suction Cup
Micro USB
cable (OTG)
Li- Ion
Battery
Trigger Area
O = Operation mode
C = Charge mode
LED Indicator
LED Indicator
Charge port
H92P
Mini
scanner
PU Glue
(Can be used
repeatedly)
