![background image](http://html.mh-extra.com/html/rh-babyandchild/mia/mia_assembly-instructions_1451069001.webp)
NO.
Qty
PARTS INCLUDED
1
Allen Key
1 piece
2
2 Pieces
DESCRIPTION
3
2 Pieces
4
Screw (3cm)
24 Pieces
5
L-Shaped Bracket
2 Pieces
TOOLS NEEDED
Phillips-head Screwdriver (not included)
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
1. Stand the Headboard (A) upright and attach Side Rails (B), as shown in Diagram I.
2.
Repeat above procedure to attach the Footboard (C).
3.
4.
Attach the Cross Support Foot (F) to the Center Support Slat (E) as shown in Diagram II.
Attach the L-Shaped Brackets (5) to the ends of Center Support Slat (D), and tighten with Allen Head
Bolt (2) and Allen Key (1). Attach the L-Shaped Brackets (5) to the Headboard (A) and Footboard (C), and
Place the Slat Roll (D) into the cleats on the inside of the Side Rails (B).
Screw the ends of the slats to the cleats using Screws (4), as shown in Diagram IV.
Page 1 of 2
tighten with Allen Head Bolt (3) and Allen Key (1), as shown in Diagram III.
5.
6
2 Pieces
MIA UPHOLSTERED NAILHEAD BED FULL & QUEEN - ASSEMBLY INSTRUCTIONS
A. HEADBOARD (1)
B. SIDE RAILS (2)
C. HEADBOARD (1)
E. CENTER SUPPORT SLAT (1)
D. SLAT ROLL (1)
F. CENTER SUPPORT SLAT FOOT (WITH ADJUSTABLE GLIDE) (1)
Allen Head Bolt (0.6cm Dia.)
Allen Head Bolt (0.8cm Dia.)