1
2
DVI Output
DVI Input
Switch
4
7
8
DVI Input Port of
Sending Card
Step 3-DVI Output
3
Outputs of Sending Card
Power
Step 4-DVI Input Port of Sending Card
Power On
Connect one end of the power with the device, the other
end into a socket, and push power switch to ON
position, then the device will work normally.
5
Step 6-Power
Plug in power cord which has IEC connector, DV4
supports AC power from 100 to 240V, 50-60Hz, which
means world wide compatible.
6
Connect to the input port of sending card,
output DVI signal to DVI input port of
sending card.
Step 5-Outputs of Sending Card
Connect to LED display.
2. Connect each DVI output interface to the
corresponding DVI input interface of sending card
with DVI cable.
3. Connect outputs of sending card to LED display
with cable.
4. Plug in power cord with IEC connector.
Same operation with the below row interfaces.
Shown as follows:
How to Work
VIEW SIZE THE WORLD
DV4
–
Quick Start
NOTE
This guide provides quick start instructions for an experienced installer
to set up and operate the DV4.
For full installation, configuration, and operation details, please refer to
the DV4 user manual, which is available at www.rgblink.com.
Installation and cabling features
Back Panel
Connections
Step 1-Mounting
Turn off or disconnect all equipment power sources.
Step 2-DVI Input
Use to input DVI from DVI player or
computer with DVI connector.
Connect to DVI output, and receive the
signal from DVI output.
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: [email protected] http://www.rgblink.cn
DV4 Quick Start
Rev 1.0
Page 1 of 2
Push power button to ON position, the device will
operate as follows:
1. Input DVI signal, each DVI input interface will
output the signal to the 2 output interfaces.
2. Output interfaces output the signal to corresponding
inputs of sending card.
3. Inputs of sending card output the signal to outputs
of sending card.
4. Outputs of sending card output the signal to LED
display.
Operation Manual
How to Connect
Operation steps are as follows:
1. Connect the device or computer with DVI interface
to the DVI input interface in above row of DV4 with
DVI cable.
