WARNING!
When the seat is adjusted properly, you should NEVER see the minimum insertion line. Do NOT operate bike if minimum
insertion line is viewable on the seat post
(Fig. 4)
.
UNPACKING YOUR BIKE
Front
25.4
MIN INSERT
25.4
Open
Close/
Tighten
FRONT
ASSEMBLY INSTRUCTIONS
B E A U M O N T M I N I
TOOLS NEEDED
(Included)
TOOLS NEEDED
(Not Included)
PLEASE KEEP THESE INSTRUCTIONS FOR
FUTURE USE & REFERENCE. DO NOT DISCARD.
WARNING:
Serious injuries and even death can occur if
the proper safety precautions are not followed.
1
Cut the shipping straps on the outside of the box.
Remove the box staples to prevent any cuts that can occur while you’re unpacking your bike. Lift bike out by frame and rear wheel.
IMPORTANT:
Rotate the fork (looks like a wishbone) so that it is facing forward of the bike
(Fig. 1).
Place the bike on the ground, so it’s standing upright on the fork
dropouts and rear tire.
Cut all of the packing zip ties.
Separate the front wheel from the bike by carefully slipping it away from the crank arm, which is resting within the spokes.
Remove the accessory box and set it aside.
Examine your new bike for any visible damage that may have occurred during shipping.
Special Note: For tightening all fasteners, please refer to Appendix D in the back of your owner’s manual for all fastener torque specifications.
SADDLE/SEAT POST
2
The seat post will come attached to the saddle from the factory. Pull the quick release lever attached to the top of the
frame seat tube outwards. Insert the seat post/saddle assembly into the seat tube of the frame to at least the minimum
insertion line of the seat post
(Fig. 2)
. Adjust the seat to your desired height.
Once you have adjusted the seat post to your desired height, lock it in place by closing the quick release lever against
the clamp
(Fig. 3)
.
*The lever should require some force to close. If it closes too easily and does not hold the seat post in place, or if the effort to close
the clamp is too great, adjust the clamping force by loosening or tightening the adjusting nut on the side opposite the lever.
1.
2.
3.
4.
5.
6.
7.
1.
2.
1
2
3
4
x3
4,5,6 mm Hex Wrench
x1
10-function multi-tool
x1
Phillips Screwdriver
x1
Scissors
1
