1of3
For Style QR3703
Please go to
for product cleaning tips. Go to the
selection.
marking pen, 1/ ”
drill bit
drill.
Integrated LED 30W
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Missing Parts? Contact your original place of
purchase.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses,
8
and
Note: This mirror can be mounted over an electrical outlet box or on the wall and plugged into an outlet.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Package Contents
A
E
Screw
x 5
Mirror
x 1
B
Wall Anchor
x 5
C
Cord Cover
Backplate
x 1
D
Cord Cover
x 2
SEPARATE MIRROR AND BACKPLATE
Figure 1A
Installation Guide #IS-QR3703
2018 QuoizelInc.
ReleasedDate:2018-04-18
visit us on-line at www.quoizel.com
Step 1A - Identify Locations for Wall Anchors
A. The template is provided to assist you in mounting the mirror. The
template is a full size drawing of your mirror and includes the wall
anchor mounting locations that can easily be transferred to the wall,
or use the mirror backplate.
Mark Wall Anchor
Locations On The Wall
At Arrow Locations
Step 2A - Installing 4 Wall Anchors and Screws
A. Using a 1/8” drill bit, drill holes at each (2) locations marked on the
wall surface.
B. Insert Wall Anchors (B) into drilled holes completely.
C. Thread Screws (A) into Wall Anchors (B) and leave approximately
3mm extending from wall surface.
A
B
Mark
Figure 2A
TEMPLATE
(Step 1A Continued)
Place the template or the mirror back plate on the wall in the location
selected for the mirror. Make sure the template or mirror back plate
is level and in the correct position. Secure the template to the wall
then mark the locations of the 4 wall anchors as indicated on the
template. Remove the template from the wall.
STEP 3A
Final Mirror Assembly
-
A. With the help of another person place the
keyholes on the back of the mirror onto
the Screws (A). Making sure each hole is
securely hung onto the Screws (A)
before letting go of the mirror backplate.
A
Figure 3A
E
Keyhole
Touch Switch
