Package Contents
Warnings and Cautions
1of2
Assembly Instruction Sheet #IS-DE8959IB
_R1
For Style DE8959IB
2017 QuoizelInc.
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
A
Crossbar Assembly
x 1
Please go to
for product cleaning tips. Go to the
selection.
(2) B10 Candelabra Base bulbs 60W Maximum.
20-30 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to ensure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
www.quoizel.com
Care + Maintenance
Light Source:
Estimated Assembly Time:
Preparation:
Fixture can only be mounted in the direction indicated on page 2.
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
C
Finial
Assembly
x 1
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
or visit us on-line at www.quoizel.com
B
Alternate
Mounting
screw
x 2
STEP 1
Remove Styrofoam
-
A. Unscrew the hex coupling on the top of the Fixture Body (D) and
remove the fixture hood from the cage.
B. Remove the Styrofoam inside of the cage.
Figure 1
Fixture
Hood
Cage
RevisedDate:2017-11-23
D
Fixture Body
x 1
Styrofoam (Remove)
Hex Coupling
D
STEP 2
Install Bulbs and Finial
Assembly
-
A. Insert bulbs onto sockets and
screw snugly into place.
B. Place the fixture hood back onto
the cage and secure with the hex
coupling. Hand tighten until
snug.
C. Remover nipple, strut member
and waterproof washer from the
finial.
D. Thread the nipple onto the hex
coupling and hand tighten until
snug. Pass the strut member and
waterproof washer over the top
end of the nipple and secure with
the finial. Hand tighten until
snug.
STEP 3
Installing the Crossbar Assembly
-
A. Pass the supply wires through the Crossbar Assembly (A). Attach
the Crossbar Assembly (A) to the Outlet Box with the head of the
Green Ground Screw facing you. Secure the Crossbar Assembly (A)
with Outlet Box Screws (not included). Tighten until snug
Note: Use the Alternate Shorter Mounting Screw (B) if your
installation requires a shorter mounting screw.
.
A
Mounting Screw
or Alternate Short
Mounting Screw
Outlet Box Screws
(not included)
Supply Wires
with Ground Wire
Outlet Box
Figure 3
Hex Coupling
Fixture
Hood
Stem
Bulb (not
supplied)
Socket
Finial
Waterproof Washer
Strut Member
Nipple
Figure 2
