HFOC-100A
User’s Manual
HDMI 2.0 Fiber Optic Active Armoured Cable
System requirements
- Check Source and Display parameters to meet the maximum resolution and standard
compatibility of the Product.
- Do not apply extra force or bend cable over its minimal radius.
- Since HFOC-100A uses Hybrid Technology, it does not provide galvanic isolation
between Source and Display interface ports (same as generic copper cable). Avoid
to install active hybrid cables when system has a ground loops issues or different line
power phase used at Source and Display installation points. It could result in failures
and electrical damages of connected equipment interfaces.
- No external power supply is needed, HFOC-100A is designed to use +5V internal
power supplied through the Source HDMI port.
- Do not use any intermediate cables or adapters between Source and Display ports
and the cable connectors.
- Do not connect or disconnect cable while Source and Display Devices are powered
On.
Installation
STEP 1
Carefully unpack the contents of the shipping group.
STEP 2
Twist the front and rear cover, distinguish both ends internal connectors.
STEP 3
Power Off all devices.
STEP 4
Plug ‘Source’ labeled connector directly to the HDMI output interface of
the Source device (Blu-Ray, Media player, PC or laptop).
STEP 5
Plug ‘Display’ labeled connector directly to the HDMI input interface of the
Display device (Monitor, Projector or Videowall).
STEP 6
Power On the Display device, then Source Device.
STEP 7
Check and correct resolutions settings at Source Device according Display
if needed.
STEP 8
Enjoy Clear and High Resolution Picture.
Qtex HFOC-100A
cables series designed to meet extremely high requirements of
modern audio-visual systems with harsh environments. Cables can support up to Ultra
HD 4K resolutions, 4:4:4 color sub-sampling along with multichannel audio include
ARC feature.
HFOC-100A
supports throughout transmission of EDID signals from a display to
source device and compatible with HDCP encrypted signals. Two miniature converter
boards integrated into the HDMI interface connectors at both cable ends, covered by
protective caps.
HFOC-100A
is designed for maximum protection from mechanical damaging with
helical steel tape armoring, at the same time polyurethane jacket and aramid fiber
give good flame retardant effect. Additionaly it gives good protection for cable when
pulling it. The installation is simple as for a general copper HDMI cable. Thanks to its
design and hybrid technology, Qtex HFOC-100A cables do not require external power
supply and should be powered directly by the HDMI interface of the source device.
Cables are premade at different lengths from 5 to 100 meters long.
© 2021 Qtex Corporation. All Rights Reserved
Revision 1.0K Dec 2021
