Universal Z-Wave Key Pad
SKU: POPE700045
Quickstart
This is a
secure Kepad
for
Europe
. To run this device please insert fresh
4 * AAA
batteries. Please make sure the internal battery is fully charged.
The device can run in two different modes determined by the way its included:
Stand-Alone:
Include
a new device
to
the keypad using key 1
Network Mode:
Be Included
into your central controller using key 4 (Central Controller is needed)
Enter Management mode by removing the back-cover (all LEDs will light up). Here is a quick overview of the commands in management mode:
Wakeup: push ring
Firmware OTA: push ring quickly followed by *
Include Node: MM-> 1 -> *
Exclude Node: MM-> 2 -> *
Primary Shift: MM-> 3 -> *
Include (as secondary): MM-> 4 -> *
Reset: MM-> 5 -> * -> * for 10 seconds
Association Set: MM-> 6 -> * -> Group-Number (2,3), then wait for device NIF for 10 seconds
Association Remove: MM-> 7 -> * -> Group-Number (2,3), then wait for device NIF for 10 seconds
New User Code: MM-> 8 -> * -> NUMBER -> * -> PIN -> *
Remove User Code: MM-> 9 -> * -> NUMBER -> *
Test the control of an included Door lock (Stand Alone Mode) : MM-> 0 -> *
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart section.
(For more information about frequency regulations please refer to
the frequency coverage overview at Sigma Designs Website
).
Z-Wave ensures a reliable communication by reconfirming every message (
two-way communication
) and
every mains powered node can act as a repeater for other nodes (
meshed network
) in case the receiver is
not in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be
used together with any other certified Z-
Wave device regardless of brand and origin
as long as both are suited for the same frequency range.
If a device supports
secure communication
it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level
of security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to
www.z-wave.info
.
Product Description
This keypad is a security enabled ZWave Plus product. An security enabled ZWave controller must be used to fully utilize this product.
The keypad allows
securely controlling devices - such as door locks - and trigger actions in a gateway – such as arm/disarm alarm system– based on the entry of certain key codes.
Additionally a bell key allows emulating a doorbell by operating e.g. a chimney or a light or both.
The device can operate in two different modes. The mode is chosen the way the device is included into a Z-Wave network:
1.
Stand Alone Mode.
In this case the keypad acts as the primary network controller and will include other devices such as e.g. a strike lock control or a
chimney. No other central controller is needed. The management of user codes is done using the keypad itself.
2.
Network Mode.
The keypad is included as additional device into an exiting network. In Z-Wave terms it will then act as secondary controller. It will send
commands to a central controller and is managed by this controller. In this mode the device can still directly control door locks but it can also be used to
trigger scenes in a central controller.
