![background image](http://html.mh-extra.com/html/philips/20mdrf20/20mdrf20_quick-use-manual_322895001.webp)
There are many ways to connect your new TV / DVD to your other equipment.This Quick-Use
Guide shows the easiest, most common connections for the TV / DVD.
IN
OUT
3
2
4
ANT.
ANT.
1
Disconnect all equipment from the power outlets.
Connect the equipment to the power outlets
only after you have finished hooking up everything. Never make or change connections with equipment
connected to the power outlet.
2
If you do not have a Cable Box, simply connect your Antenna or Cable TV signal directly to the
ANT(enna) jack on the rear of the TV / DVD.
3
Or, if you do have a Cable Box or Satellite Receiver, first connect the Cable TV or Satellite
signal to the IN jack on the Cable Box or Satellite Receiver. Then, use an RF coaxial cable (not
supplied) to connect the OUT jack of the Cable Box or Satellite Receiver to the ANT(enna) jack
on the TV / DVD.
To view any channel, set the TV / DVD to the output channel of the Cable Box or Satellite
Receiver (channel 3 or 4).Then, select channels at the Cable Box or Satellite Receiver.
4
When all connections are complete, plug the power cord of the TV / DVD into an active
power outlet.
5
Press the STANDBY-ON button on the TV / DVD or its remote to turn on the TV / DVD. The
first time you turn on the TV / DVD, you should complete the TV / DVD setup. See the other
side of this Quick-Use Guide for details.
Quick-Use Guide
Quick-Use Guide