30622-01A - Page 1
DANGER
Ultraviolet radiation. Follow instructions. Avoid overexposure. As with
natural sunlight, overexposure can cause eye and skin injury and
allergic reactions. Repeated exposure may cause premature aging of the skin and skin can-
cer. WEAR PROTECTIVE EYEWEAR; FAILURE TO MAY RESULT IN SEVERE BURNS OR
LONGTERM INJURY TO THE EYES. Medications or cosmetics may increase your sensitivity
to the ultraviolet radiation. Consult physician before using sunlamp if you are using medications
or have a history of skin problems or believe yourself especially sensitive to sunlight. If you do
not tan in the sun, you are unlikely to tan from the use of this product. Children, the elderly, or
fair skinned people who always burn easily and either never tan or tan minimally should not
use this equipment.
To use, lie down on bench and pull canopy down as far as adjustment will allow maintaining at
least 2 inches (5.1 centimeters) between your body and canopy clear plastic panel, otherwise
overexposure may occur. Do not use without clear plastic panels in place. Untanned persons
should not tan on consecutive days during their
fi
rst week of tanning. Never tan more than once
a day. Tanning normally appears after the
fi
rst few sessions and maximizes after approximately
four weeks. Tan once or twice per week thereafter to maintain appearance. Persons already
having a base tan may begin at advanced levels corresponding to the extent of their base tan.
Skin Type:
I Sensitive Skin (Burns easily and severely and does not tan.)
II Light Skin
(Burns easily and severely and tans minimally.)
III Normal Skin
(Burns moderately and tans average.)
IV Dark Skin
(Burns minimally, tans easily and above average.)
New lamps emit approximately 10% more ultraviolet radiation during the
fi
rst 50 hours of opera-
tion. Recommended tanning times should therefore be reduced by approximately 10% during
that period.
WARNING: • Read these instructions before using this sunlamp product. • All persons in the
room should wear protective eyewear when lamps are on. Recommended eyewear: provided
eyeshields or equivalent eyewear as de
fi
ned under 21 CFR 1040.20. Other types of eyewear
may not provide adequate protection. Failure to use protective eyewear may result in severe
burns or other eye injury. If discomfort develops, discontinue use and consult a physician.
THE FOLLOWING LAMPS HAVE BEEN CERTIFIED FOR USE IN THE 28 2F:
PS MAX Wolff® Model PSM71-T12-100W BI-PIN
(
below) -or-
DARK TAN® Wolff® Model DT71-T12-100W BI-PIN
(
below)
PS EXTREME Wolff® Model PSE71-T12-100W BI-PIN
(
below) -or-
DARK TAN® PLUS Wolff® Model DTP71-T12-100W BI-PIN
(
below)
Heraeus E400 HPT, Philips Model HPA 400/30s or CosmoTech Model 23045
(Facial Lamps)
THIS EQUIPMENT MUST BE EARTH GROUNDED.
This product is in conformity with performance standards
for sun lamp products under 21 CFR PART 1040.20 and
ANSI/UL Standard 482.
Disconnect power cord before attempting to clean, relamp,
or engage in the maintenance of this product
RECOMMENDED EXPOSURE TIMES IN MINUTES
Level 1/Week 1
Level 2
Level 3
Level 4
Level 5
Skin Type:
1st-3rd Sessions
I Sensitive
NOT RECOMMENDED FOR TANNING
II Light
2
4
6
8
11
III Normal
3
5
8
11
11
IV Dark
4
6
9
11
11
MAXIMUM EXPOSURE TIME IS 11 MINUTES
88465
Electrical Requirements
Your sunbed operates from a
220V AC
source. You should have a
NEMA #L6-30R
electrical outlet (below) on a dedicated circuit capable
of providing
30 Amp
service, installed in the room in which you will
use the unit. We recommend installation by a professional electrician.
The outlet must be earth grounded.
30 AMP NEMA #L6-30R
RECEPTACLE
DANGER
Shock hazard.
Disconnect power before servicing or removing any protec-
tive covers.
Do not operate this device near water or while you are wet.
DANGER
Some medications may increase your sensitivity to ultraviolet light. It
is recommended that you consult a physician before using this sun-
bed if taking any medication or if you suspect that your skin might be
especially sensitive to sunlight.
WARNING
Wear protective eyewear.
Failure to may result in severe burns or longterm injury to the eyes.
CAUTION
Use of a voltage source over 230V AC may prevent proper operation
of the sunbed and could cause damage and void the warranty.
Air from the room is used to cool the sunbed. Maximum ambient room
temperature should be 80°F. Place your sunbed no closer than 6” from
any wall. Make sure nothing obstructs the air
fl
ow into the sunbed’s
endcaps or out of the fan openings. A poorly ventilated room may
cause the unit to become hot and cause discomfort to the user.
Hardware Inventory
(These items and a small pillow)
Allen-head Bolt 5/16” x 1”
Quantity 2
Hinge Brackets
(1) left, (1) right
5/16” Metal Washer
Quantity 2
Bushing
Quantity 2
Allen-head Bolt 5/16” x 1 1/2”
Quantity 2
Hex (Allen) Wrench
Quantity 1
Safety Goggles
Quantity 1
Nylon Washer
Quantity 2
Tree Fastener
Quantity 4
Star Lock Washer
Quantity 8
#10-32 x 1/2” screw
Quantity 8
Skirt Retaining Bracket
Quantity 2
Skirt Mounting Bracket
Quantity 1-left, 1-right
