INSTALLATION INSTRUCTIONS
ATTENTION INSTALLER (if other than owner):
Please forward this instruction sheet to the purchaser of this
product. These instructions contain valuable information
necessary to the end user.
Particularly important information is distinguished in these
instructions by the following notations:
NOTE: A NOTE provides key information to make
procedures easier or clearer.
CAUTION: A CAUTION indicates special procedures that
must be followed to avoid damage to the motorcycle and/
or accessories.
WARNING!:
A WARNING indicates special procedures
that must be followed to avoid injury to a motorcycle
operator or person inspecting or repairing the motorcycle.
3501 Kennedy Rd, PO Box 5222, Janesville, WI 53547-5222
P/N DS-319934
REVISED 3/2012
Page 1 of 4
PARTS UNLIMITED
REAR SPEAKER KIT FOR 1988-2000 GL1500
P/N DS-319934
INTRODUCTION: These instructions describe the
procedure for properly installing a rear speaker kit onto the
1988-2000 Honda GL1500 models. Review instructions
carefully before beginning, as they contain important
information. Please retain for future reference.
TOOLS REQUIRED:
6mm hex wrench
Flat blade screwdriver
Center punch
#2 medium Phillips screwdriver
10mm wrench
Hammer
PROCEDURE:
1. Remove left side cover (Item #1A) by grasping the front
and pulling sharply outward to disengage the three
bosses (Item #1B) and the rubber hole (Item #1C) from
the frame.
2. Using a 6mm hex wrench, remove the four socket bolts
(Item #1D) and left and right passenger hand grips
(Item #1E).
3. Grasp seat cushion rear flap (Item #1F) and pull upward
toward the rear to disengage the seat front hook
(Item #1G). Remove seat (Item #1H) and set carefully
to one side.
4. Unsnap and remove the fairing left-hand pocket cover
(Item #2A).
5. Using a #2 medium Phillips screwdriver, remove the
four screws (Item #2B) securing left-hand pocket
(Item #2C) and remove pocket.
6. Remove left-side engine cover (Item #3A) by grasping
the rear end and pulling sharply outward and toward
the rear to disengage the boss (Item #3A ) and two tabs
(Item #3C).
7. Using a flat blade screwdriver, pry off left-hand screw
cover (Item #4A) from left-hand lower fairing cover
molding trim (Item #4B).
8. Using a #2 medium Phillips screwdriver, remove screw
(Item #4C) and left-hand lower fairing corner molding
trim (Item #4B).
9. Remove left-hand cowl trim molding (Item #4D) by
pulling outward. Remove ignition switch cover
(Item #4E) by grasping under both sides near rear and
pulling sharply upward and toward rear.
