Panduit N2RCFR Installation Instructions Download

Page: 1 / 3

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

V00029CX

Page 1 of 3

-A

CCESS

N-Type Switch Cabinets

Part numbers:

(N2RCFR, N5RCFR, N8RCFR, N1RCFR Set of Four Cage Nut Equipment Rails)

(N2RTFR, N5RTFR, N8RTFR, N1RTFR Set of Four Tapped Equipment Rails)

Front Equipment Rail Installation

•

Remove existing front rails from cabinet posts (use T25 Torx bit to remove existing screws)

•

Install [2] Front Equipment Rails to Front Cabinet Posts with [5] Countersunk Torx screws per rail (use T25 Torx bit)

•

Use supplied shims (as necessary) to ensure proper EIA spacing of front equipment rails

Countersunk Torx Screw

(use T25 Torx bit)

[5] screws per rail

REMOVE EXISITING
FRONT EQUIPMENT RAILS

(use T25 Torx bit)

Shim

(**use as necessary**)

FALLING EQUIPMENT HAZARD

Remove all equipment installed onto equipment rails before performing any adjustments to equipment rail spacing.

FAILURE TO FOLLOW THESE INSTRUCTIONS CAN LEAD TO SERIOUS INJURY, DEATH, OR DAMAGE TO YOUR EQUIPMENT.

WARNING

Summary of Contents for N2RCFR

Page 1: ...t to remove existing screws Install 2 Front Equipment Rails to Front Cabinet Posts with 5 Countersunk Torx screws per rail use T25 Torx bit Use supplied shims as necessary to ensure proper EIA spacing...

Page 2: ...Installation Install 4 Equipment Rail Mounting Brackets to Equipment Rails with 3 Countersunk Torx screws per bracket use T25 Torx bit Ensure that countersunk holes of brackets are oriented to match...

Page 3: ...rip Area Barbed Surface face to outside of cabinet Rear Equipment Rail Installation Locate desired Equipment Rail position Insert 2 Equipment Rail Mount Nuts through slots of Front to Back Beam top an...