![background image](http://html.mh-extra.com/html/commscope/rfp/rfp_installation-and-cable-routing-instructions_2643720001.webp)
1
Dimensions
2
Preparing RFP for installation onto the wall
•
Within the appropriate location mount the wall mount bracket to the wall using two screws provided
3
Assemble Face Plate to support bracket
Align the face plate 90 degrees to the support bracket and push the assembly together .
Rapid Face Plate– RFP
Wall Mount Installation and Cable Routing Instructions
Infrared radiation is invisible and can seriously damage the retina of the eye. Do not look into the ends of any optical fibre. Do not
look directly into the optical adaptor. Exposure to invisible laser radiation may result. A protective cap or hood must be immediately
placed over any radiating adapter or optical fibre connector to avoid the potential of dangerous amounts of radiation exposure The
practice also prevents dirt particles from entering the connector and adapter
Issue 3 – 16/08/13
Page
1
of 2
PUSH THE FACE PLATE ONTO THE
SUPPORT BRACKET
4
UNSPOOL CABLE AND ROUTE TO EQUIPMENT
PULL FROM HAULING EYE
(MAXIMUM HAULING FORCE
SHOULD NOT EXCEED 7KG)
Using the hauling eye Gently pull the cable, make sure the RFP spins freely (DO NOT
EXCEED 7KG PULLING FORCE)
RFP WILL SPIN
DURING
INSTALLATION
WALL MOUNTING
BRACKET
POSITION THE FACE PLATE 90° TO
THE CAVITY SUPPORT BRACKET
115mm
52mm
75mm
ENSURE SURFACE MOUNT
BOX IS ORIENTATED
HORIZONTALLY
MARK AND SECURE TO
THE WALL USING THE
FIXINGS PROVIDED
NOTE RFP REMOVED FOR PICTURE CLARITY
SELECT APPROPRIATE PORT TO BE
UTILISED ON SUPPORT BRACKET
AND BREAKOUT PLASTIC COVER