1
SPARTAN 3CCT SELECTABLE IP65 LED BULKHEAD INSTRUCTIONS
Issue 02 on 6
th
March 2021
THANK YOU
for buying this product. To help ensure it gives complete satisfaction please install it according to these
instructions and then pass the instructions to the appropriate person for retention and future reference.
SAFETY
This is a mains powered product. It is designed to be installed by suitably qualified personnel
only and in accordance with the applicable building and electrical regulations. Before installation or
maintenance the electrical supply to the product must be isolated.
INSTALLATION SUPPORT
If installation advice or accessories are required please contact us at the
above address. We will do our best to help. When reporting a suspected fault or seeking installation support the problem
is likely to be resolved most quickly if you have full product details to-hand, as well as details of when and where it was
purchased.
INSTALLATION
1. Loosen the 3 diffuser fixing screws & remove the diffuser geartray assembly from the base by unhooking the
retention strap.
2. Prepare the mains supply cable & fixing points on the chosen mounting surface ensuring it is able to retain the
weight of the luminaire.
3. Pass the mains supply cable through the cable entry hole, offer the base to the mounting surface & secure using
the screws provided.
Note! It is the installer’s responsibility to ensure the fixing points & cable entry point are appropriately
sealed to maintain the IP rating
4. Route the mains supply cable to the terminal block on the gear tray & terminate ensuring correct polarity is
observed.
Note! This luminaire must be earthed
5. Select the required CCT by sliding the switch on the back of the gear tray to the allocated colour
6. Refit the diffuser gear tray assembly (opposite of point 1) & secure by retightening the screws.
7. Reconnect power supply & check for correct operation.
Note! Luminaires fitted with electronic drivers are exempt from insulation resistance tests as this may
cause damage to the drivers.
8. For suffix ../M3 and suffix…/MW versions see further instructions below.
BEZEL TRIMS
If this option has been selected, then install as follows:
1. Offer the bezel trim to the main luminaire aligning the lugs in the trim with the screw slots in the diffuser (3
places).
2. Push fit until it clips into position.
Note! If eyelid trim is selected then care will need to be taken to ensure slots are in the correct position when
securing the base.
MAINTENANCE
1. Cleaning should be carried out at regular intervals so as not impair photometric performance or thermal safety of
the luminaire.
