AG 2100 Quick Start
P/N 300-1235-001-A
|Page 1 of 10 |
Copyright © 2005 Nomadix, Inc.
Introduction
This document provides instructions for getting started with the Nomadix Wireless Access
Gateway 2100 (AG 2100) product. If you have any problems, please contact our technical
support team at +1.818.575.2590, or email: [email protected].
The AG 2100 has three network interface configuration modes:
1)
Static
2)
DHCP Client
3)
PPPoE Client
By default, the ‘DHCP Client’ configuration mode is enabled.
There are two ways to configure the Nomadix Wireless Access Gateways:
1)
Network side as shown in Figure 1.
2)
Subscriber side as shown in Figure 2.
By default, only the SSH interface is available on the subscriber-side. All interfaces are available
on the network-side.
Requirement Checklist
You will need the following items to configure the AG 2100
•
Laptop or PC
•
Hub
•
Three (3) Ethernet cables
•
Wireless card (optional)
•
SSH client
Start Here
1.
Unpack the Access Gateway and place it on a flat and stable work surface.
2.
Select the side on which to access the management interface of the NSE gateway.
