background image

Nilfisk-Advance A/S
Sognevej 25
DK-2605 Brøndby
Denmark

Tel.: +45 43 23 40 50
Fax: +45 43 43 77 00
[email protected]
www.nilfisk.com

ATTENTION!

 Do not use the machine before you have read and understood the User Manual

2. Fill the tank with a solution suitable 
for the work to be performed.
Always follow the dilution instructions 
on the label of the chemical product 
used to prepare the solution. Its tem-
perature must not exceed 40°C.

1  Disconnect the battery charger cable 

from the electrical main.

3.  Install the squeegee and fasten it 

with the handwheels, then connect 
the vacuum hose to the squeegee.

4.  Place the brush or the pad-holder 

under the deck. Use the appropriate 
brush to clean the floor. 

17.  Charge the batteries: Connect the 

battery charger cable to the  
electrical main

15.    Check and clean the squeegee 

blades 

16.  Clean the machine using a damp 

cloth and where needed use a  
neutral cleaning product

18.  Park the machine with the recovery 

tank cover open

12. 

 

 Clean the filter by: Remove the 
transparent cover and the gasket

10. 

At the end of the work. 

Empty 

the recovery tank with the hose. Then 
empty the solution tank with the 
trasparent hose

11.  Wash with clean water the recovery 

tank and the vacuum grid

13.  Remove the brush/pad and clean 

them

14.  Take the squeegee off and remove 

debris.

7.  Press the solution flow control  

switch as necessary, depending on the 
type of cleaning to be performed 

5.   Switch on the brush and vac motors 

to activate the machine

6.  Press the handle switch to engage 

the brush and run the machine

8.      Lower the squeegee with the lever.

9.  Press the enabling push-button together 

with the brush levers for starting floor 
cleaning. If solution applied flows outside 
the brush housing during use, reduce the 
flow of solution.

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to 
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

OPERATING GUIDELINES 
SC400

All manuals and user guides at all-guides.com

all-guides.com

Reviews: