AAM8000-12, AAM8000-24 and AAM8000-24B
12-Port and 24-Port ADSL Access Multiplexers with Full Rate and G.lite Operational Modes
1.0 ADSL ACCESS MULTIPLEXER MODEL TYPES
The AAM8000-12 and the AAM8000-24 (Annex A) are twelve and twenty-four port ADSL Access
Multiplexers, with both Full Rate and G.lite operational modes, that support Plain Old Telephone Service
(POTS) across lower frequencies (up to 4 kHz).
The AAM8000-24B (Annex B) is a 24-port Access Multiplexer, with both Full Rate and G.lite operational
modes, that supports Integrated Services Digital Network (ISDN) across lower frequencies: up to 80 kHz
over a Two Binary, One Quaternary (2B1Q) line and up to 100 kHz over a Four Binary, Three Ternary (4B3T)
line.
All three of the above ADSL Access Multiplexer models exceed the International Telecommunications
Union Telecommunication Standardization Sector (ITU-T) Recommendation G.992.1 minimum
requirements of 640 kbps upstream and 6,000 kbps downstream.
2.0 INSTALLATION
2.1 Unpack and inspect the AAM8000
If there is visible damage, do not attempt to connect the device; contact Customer Support at 1-877-
638-2638 (001-603-427-0600 for international customers) or [email protected].
2.2 Install the AAM8000 in an IP DSLAM chassis
Net to Net Technologies' IP DSLAM interface modules are hot swappable; installing or removing an
interface module while the chassis is powered up does not affect the operational status of other
interface modules within the chassis. The IPD12000 is a fourteen slot chassis; slots 1-12 are
reserved for interface modules (such as the AAM8000) and slots 13-14 are reserved for MUMs.
Interface modules may be placed in any order in slots 1-12. The IPD4000 is a five slot chassis; slots
1-4 are reserved for interface modules and slot 5 is reserved for a MUM.
Interface Module User Guide
C
AUTION
Net to Net Technologies strongly recommends the use of proper electrostatic discharge (ESD) precautions when
handling this equipment.
N
OTE
There must be a Multiplexer Uplink Module (MUM) installed in the IP DSLAM chassis in order for interface
modules to operate.
210-0000039 rev 07
