background image

 
 

 

 

                          

 

Operating and Maintenance Instructions 

 

Model: 6625 

Fresh - O - Matic ® Food Steamer 

 

1    

 

 

                                 

NEMCO FOOD EQUIPMENT

      

301 Meuse Argonne, Hicksville, OH 43526 

Phone: (419) 542-7751     Fax: (419) 542-6690    Toll free: 1-800-782-6761 

www.nemcofoodequip.com 

 

 

 

48182 

1/17/2011 

             

INTRODUCTION 

1.

 

Please read instructions before using this appliance. 

2.

 

When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and 
injury. 

3.

 

Clean machine thoroughly before and after all uses following cleaning instructions below.   

 

ELECTRICAL REQUIREMENTS 

Plug steamer into a grounded outlet with correct voltage and sufficient power capacity. Refer to the product label (serial plate) on the 
Fresh-O-Matic ® for voltage and wattage requirements.  

 

 

SAFETY INSTRUCTIONS 

1.

 

Warning!

 All power must be disconnected at power source before any service procedure is performed. 

2.

 

This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials, such as 
drapes and other furnishings, away from appliance. 

3.

 

Extreme caution is necessary when any appliance is used by or near children and whenever the appliance is left unattended. 

4.

 

Always unplug appliance when not in use and before cleaning, adjusting or maintaining this machine. To disconnect appliance, 
turn controls off and remove plug from power source. 

5.

 

Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions, has been dropped, or damaged.  
Return appliance to an authorized service facility for examination, electrical or mechanical adjustment, or repair. 

6.

 

Do not use outdoors. This appliance is not intended for use in wet or moist locations.  Never locate appliance where it may fall 
into water. 

7.

 

Connect to properly grounded outlets only. Avoid the use of extension cords

.  

Do not run cord under carpeting, runners, or the 

like.  Arrange cord away from traffic area and where it will not be tripped over. 

8.

 

This appliance is equipped with a power cord with a three-blade plug. Plug ONLY into a matching three-blade outlet. DO NOT 
cut or break off the third blade or attempt to use with a two-blade extension cord. 

9.

 

To prevent a possible fire, it is recommended that the unit is placed on a non-combustible surface. 

10.

 

This appliance has electrical parts. Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.

 

 

PREPARATION 

1.

 

Set Fresh-O-Matic ® on a flat stable surface, near the power source. 

2.

 

Clean Fresh-O-Matic ® thoroughly before use. 

3.

 

If unit fails to work properly when first operated call NEMCO customer service at 1-800-782-6761. 

 

 

OPERATION  

1.

 

Plug CORD into grounded electrical outlet of the correct voltage.  Electrical shock can occur if appliance is not grounded. 

2.

 

Press power button. The power light, water level light(s), and heating light  will illuminate at the same time. 

3.

 

Lift "Snap Cap." 

4.

 

Fill water tank with only 

DISTILLED WATER

 to "FULL" level shown on water level light (approximately 4-1/2 quarts).          

Note: Do not use De-Ionized or Reverse Osmosis water. Refill as necessary - being sure to stop when the green light is 
illuminated. 

DO NOT OVERFILL. 

A funnel may be used, with care.  

5.

 

There is approximately 1/2 quart of water in the tank when the "Low Level (Red) Light" is on. The steam button may be used 
while the red light is on. The "Low Level (Red) Light" will blink when the tank is empty and must be filled. 

6.

 

Fresh-O-Matic ® is ready for use when heating light goes off first time. Light will go on and off periodically, indicating operating 
temperature is being maintained.  

7.

 

Lift cover; place food to be served in the Fresh-O-Matic ®. 

8.

 

Close cover; press Steam Button two (2) times approximately every 30 seconds. Note: Each push of the steam button releases 
approximately 10 cc's (1/3 ounce) of steam/water. See "Cooking Options" for complete instructions. 

9.

 

When first filling the Fresh-O-Matic ®, the steam button may need to be pressed and held approximately 5-10 seconds (once or 
twice) in order to prime the water pump. 

10.

 

Open cover; food is hot, ready to serve.   

NOTE:

 It is important to keep Fresh-O-Matic ® cover closed between uses so that proper temperature is maintained for maximum 

efficiency. The cover must be closed to visually see steam and hold steam. Pressing and holding the Steam Button will rapidly cool 
the heating  plate causing lengthy reheating time. 

Summary of Contents for Fresh-O-Matic 6625

Page 1: ...T cut or break off the third blade or attempt to use with a two blade extension cord 9 To prevent a possible fire it is recommended that the unit is placed on a non combustible surface 10 This appliance has electrical parts Do not use it in areas where gasoline paint or flammable liquids are used or stored PREPARATION 1 Set Fresh O Matic on a flat stable surface near the power source 2 Clean Fresh...

Page 2: ...re cleaning or moving 2 Move the unit to the edge of a sink with the back of the unit slightly over the edge of the sink 3 Remove the hose clamp and drain cap 4 Allow the water to drain from the tank and filter Tip the unit slightly to remove the most water 5 Replace the drain plug 6 Refill the tank flush and drain again if necessary 7 Replace the drain plug and hose clamp COOKING OPTIONS Main Dis...

Page 3: ...below PRE COOKED FRUITS AND VEGETABLES CANNED OR ROOM TEMPERATURE HEATING TIME From Canned or Room Temperature Water Packaged Vegetables 2 minutes Creamed Vegetables 3 to 3 1 2 minutes Glazed Pineapple Ring 1 1 2 minutes Glazed peach Half 2 to 2 1 2 minutes Applesauce 2 1 2 to 3 minutes Refrigerated cooked vegetables will take approximately 30 seconds longer GRAVY AND SAUCES HEATING TIME From Cann...

Page 4: ...unit more time to recover NOTE Light will stay lit during start up 20 minutes Water Under Unit Overfilling or tipping the unit Condensation from under the cover Do not overfill or tip unit Check hose connections and secure if necessary Water On Plate Pressing steam button to often or holding down the steam button Allow 30 second between each demand for steam No Steam Unit has cooled by holding the...

Reviews: