Assembly Instructions
and Owner’s Manual
Description:
Quantum® Hardcoated Polycarbonate
UTV Windshield,
Wash’n’Wipe™
Full Size
Model:
Polaris Ranger Full Size, Rd.
Frame Tube, Various Models
Part Number:
N30208
Installation Time:
60 min.
Thank you for purchasing a National Cycle product. Read these instructions carefully and thoroughly before beginning work.
Dealers, if installing this windshield for a customer, please give them this manual. It contains information needed to properly
maintain and use this product.
Attention:
Special notes and cautionary measures which can pre-
vent damage to the accessory or vehicle.
Note:
Tips for facilitation of operation, control and adjust-
ment, as well as maintenance work.
Item
Part No.
Description
Qty.
Notes and Tools
1
20-290402-000
Windscreen, Upper Section
1
Grommets Installed
2
20-290433-000
Windscreen, Lower Section
1
Grommets and Velcro Fastener Installed
3
44-447165-000
Grommets for Windshield
9
Installed on Windscreen
4
77-771152-001
Marine Grade Velcro, Hook
2
Installed on Windscreen
5
77-771153-001
Marine Grade Velcro, Loop
2
Installed on Windscreen
6
80-875150-000
Motor Assembly
1
Installed on Windscreen
7
80-875153-000
Arm, Wiper Assembly, 14” 350mm
1
Replacement Blade Part No. is N30910
8
80-875155-000
Blade, Wiper Assembly, 16” (406mm)
1
Replacement Blade Part No. is N30901
9
44-447002-000
Foam Tape, 1/8 x 1” W
1
Installed on Windscreen
KIT
10
44-442523-000
Reservoir & Pump Assembly
1
11
80-830326-000
Wire Harness and Switch
1
With Grommet and Switch,
Page 2
Parts Installed on Two-Part Windscreen
Tools Required
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-0400 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 1 of 12
10-118025-000 04/15
PREPARATION
This Kit has been carefully packed and inspected at the factory. Report any missing part directly to National Cycle, Inc.
along with the Bag No. and Date on outside of Windshield Carton.
Carefully unpack the windshield, sort the parts, and make sure you have everything required to complete the installation
to the vehicle.
TOOL LIST
Flat Blade Screwdriver
Marker
X-Acto® Knife, or similar
Wire Cutters
Power Drill with 3/4” (19mm) hole saw, or similar
Small Drill Bit (1/8”) (3mm) for pilot hole
#2 or #3 Phillips Screw Driver or Phillips Bit for Drill
Parts List Continues on Next Page
KIT
RESERVOIR and
WIRE HARNESS
(Harness, Page 2)
3 x9
1 x1
6 x1
7 x1
8 x1
2 x1
9 x1
4 x2
5 x2
10 x1
