![background image](http://html1.mh-extra.com/html/napco/gem-sm/gem-sm_installation-instructions_3306959001.webp)
Description.
Description. The GEM-SMK is a high-quality photoelec-
tric smoke detector with built-in supervised digitally-coded
radio transmitter. It is compatible with Napco’s GEM-RECV
Series supervised security receivers that monitor alarms,
restores, low battery and status.
The GEM-SMK sounds a local alarm as soon as smoke is
detected and the transmitter will send an alarm signal to the
supervised receiver. The alarm signal will be repeated every
10 seconds thereafter as long as smoke is still present. A
restore report will be sent when the smoke-detection cham-
ber clears. Supervisory status reports are sent from the
GEM-SMK every hour.
Coding switches are not required or used in the GEM-
SMK. Each transmitter is assigned a unique identification
code number at the factory.
The smoke detector and transmitter are powered by two
9-volt alkaline batteries (supplied) which can power the unit
for up to two years. If the battery voltage drops below
normal, a low-battery report will be sent to the receiver with
any status or alarm transmission. If a low-battery condition
is indicated, replace
both
batteries. Note:
Note: Temperature and
humidity extremes may reduce the life of the battery.
GEM-SMK
GEM-SMK
Supervised
Supervised
Digital Smoke Detector
Digital Smoke Detector
© Napco 1998 WI750A 12/96
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
NAPCO SECURITY SYSTEMS,
NAPCO SECURITY SYSTEMS,
INC.
INC.
333 BAYVIEW AVENUE
333 BAYVIEW AVENUE
AMITYVILLE, NEW YORK
AMITYVILLE, NEW YORK
11701
11701
Step 1. Remove the mounting plate.
Step 1. Remove the mounting plate. Remove the GEM-
SMK mounting plate by turning the plate counterclockwise
and pulling it up.
Step 2. Identify components.
Step 2. Identify components. Examine the GEM-SMK
to identify the component locations.
Step 3. Install batteries.
Step 3. Install batteries. Connect the two 9-volt alkaline
batteries and place them into the battery holding clips.
Step 4. Pick smoke-detector location.
Step 4. Pick smoke-detector location. Referring to the
NFPA standard on page 3, select a good location to mount
the GEM-SMK.
Mounting the GEM-SMK on foil-backed
wallpaper or on metal single-gang electrical box is not
recommended because the radio range will be reduced.