REPLACING THE
BRITA MEMO
BRITA Memo - the electronic
cartridge exchange reminder has
a life of approximately 5 years. At
the end of the Memo’s life,
please remember that it is an
electronic device and to dispose
of the Memo according to all
applicable provisions and
regulations. To remove the
exhausted Memo, place a
screwdriver in the notch next to
the Memo and push it out.
Please note that Memo should
not be removed for any other
reason than to dispose of it.
More information on the use of
BRITA filter cartridges and the
BRITA Memo can be found in the
BRITA information guide supplied
with the kettle.
Telephone our replacement parts
helpline for your new BRITA
Memo.
SWITCHING ON
You do not need to wait until the
water has filtered through before
boiling. Your Morphy Richards
filter kettle will boil and filter at
the same time, giving you boiled
BRITA filtered water quickly.
• Boil only as much water as you
need, as this saves electricity.
1
Place the filter kettle on the base
unit, ensuring the kettle locates
on to the 360° connector.
• The 360° connector allows the
kettle to be located at any
position - ideal for left and right
handed users and convenient
positioning on a worktop.
2
Plug in and switch on at the wall
socket.
3
Switch the kettle on. The kettle
will illuminate internally.
4
When the water boils, the filter
kettle will switch off automatically.
• If you are using the kettle for the
first time, discard the water and
repeat once more.
• To re-boil, switch to ON again. If
the kettle has just switched off,
wait a minute or so before
switching it back on again.
• If you do not put in enough water,
or switch on the filter kettle when
it is empty, the safety cut-out will
switch off the power
automatically. If this happens,
refill and wait a few minutes for
the element to cool, then use as
normal.
5
Lift the filter kettle from the base
unit by the handle, ensuring you
hold the kettle level.
WARNING: Unless the
cartridge holder is fitted
correctly, the filter kettle may
not operate correctly and the
lid may not close and lock
securely.
WHEN TO
CHANGE YOUR
BRITA MAXTRA
CARTRIDGE
This depends on water quality
and the improvement required.
We recommend that you change
your cartridge after 4 weeks.
The electronic reminder on your
Morphy Richards water filter
kettle will remind you when to
change your cartridge.
BRITA filter cartridges conform to
the highest quality standards.
Raw materials and final products
are subject to stringent internal
and external controls. BRITA filter
cartridges are steam sterilised.
An independent institute certifies
the food grade quality of BRITA
water filters and cartridges.
Great taste, less waste:
The BRITA MAXTRA cartridge is
100% recyclable. Please contact
BRITA customer care team for
advice on recycling schemes on
0844 742 4800
, or visit
www.brita.co.uk/recycle
H
.
HINTS AND TIPS
Cleaning and
maintenance
WARNING: Always
disconnect the plug from the
mains and allow the
appliance to cool before
cleaning.
Wipe the outside with a damp
cloth.
IMPORTANT: Do not use abrasive
cleaners on the outside of the
appliance, as they may scratch
the surface.
HELPLINE
If you have any difficulty with
your appliance, do not hesitate to
call. We are more likely to be able
to help than the store where you
bought it.
If you require assistance on using
your BRITA MAXTRA filter
cartridge or BRITA Memo, please
call BRITA Customer Care team
on the telephone number below
Please have the following
information ready to enable our
staff to deal with your enquiry
quickly:
• Name of the product
• Model number as shown on the
underside of the appliance.
• Serial number as shown on
underside of the appliance.
UK Helpline 0844 871 0954
BRITA Helpline 0844 742 4800
Spare Parts
0844 873 0720
Ireland Helpline 1800 409 119
WEBSITE
You may also contact us through
our website, or visit the site to
browse and purchase appliances,
spare parts and accessories from
the extensive Morphy Richards
range.
5
UK Helpline 0844 871 0954
Replacement Parts 0844 873 0720
Ireland Helpline 1800 409 119
H
43541 Rev2:x 20/11/2009 15:18 Page 1
