![background image](http://html1.mh-extra.com/html/milkcan/mcl13040/mcl13040_quick-start-manual_1795503001.webp)
20cm
20cm
13 Line
Fold Down Clothesline
MCL13040
1 x Accessories Bag
2 x Front Bars
Contents
Your carton should contain the following parts:
1 x Front Brace
1 x Line Cord
2 x Side Arms (assembled)
2 x Wall Brackets
Wall
Bracket
Line Cord
Telescopic
Strut
Side Arm
Front Bar
Front Brace
Line
Tensioner
Tools
Required
- Timber or Masonry Drill Bits
- Tape Measure
- Drill / Hammer drill (ideal)
- Spanner
- Pencil
Optional
- Spirit Level
- Hack Saw (if shortening width)
Choosing a Suitable Location
The recommended mounting height of the top slotted hole in the wall bracket is:
USERS 10cm.
Minimum height is 160cm.
Installation and Assembly
1. Mark position of wall brackets to an overall width of 240cm between centres. If your required width is less than 240cm, please refer to
Reducing the Overall Width below.
If you are using a Milkcan Ground Mount Kit, skip steps 1 & 2 and refer to instructions inside the ground mount kit packaging.
Reducing the Overall Width
- For this example, we are assuming your required
overall width is 200cm. This is a total reduction of
40cm.
- Cut half from each side of the 2 x cross bar
segments i.e. 40 / 2 = 20cm each side
If your available space doesn’t allow the full 240cm
width, you can reduce the width of your Clothesline as
follows:
3.0
The cuts will be
covered by the
cross brace
www.milkcan.com.au
(03) 9464 6964
56 Northgate Drive,
Thomastown VIC 3043