background image

Rozměry pro instalaci (mm)

LED reflektory Delta 

Delta 50, Delta 100, Delta 150
Delta 200, Delta 300 

LED reflectors Delta 

Delta 50, Delta 100, Delta 150
Delta 200, Delta 300 

LED scheinwerfer Delta 

Delta 50, Delta 100, Delta 150
Delta 200, Delta 300 

Produkt opatrně rozbalte a zkontrolujte
Pokud je nový produkt jakkoliv poškozen, okamžitě ho reklamujte v původním balení
Prosíme, nepokoušejte se používat poškozený výrobek
Svítídlo nepřipojujte k elektrické síti, je-li pod napětím 

Než začnete s instalací

Instalační manuál

Poznámky k bezpečnosti:

- v případě, že dojde k rozbití skla, světlo nepoužívejte a zajistěte jeho výměnu

- důležité: Nedotýkat se světla při provozu či krátce po vypnutí - hrozí popálení! 

   Nechte svítidlo vychladnout! - nezakrývat, umístit mimo dosah hořlavých látek

- varování: vyhněte se styku vnitřních částí svítidla s vodou

- nedívejte se z malé vzdálenosti do svítidla, vystavujete se riziku poškození zraku

- nestmívat! Rozhodně nepoužívat v kombinaci se stmívatelnými okruhy

- nerozebírejte svítidlo - nezasahujte a nepřenastavujte nastavovací prvky 

  elektronických obvodů svítidla.

- instalaci a servis mohou provádět pouze kvalifikované osoby.

Instalace

Zkontrolujte správné zapojení a zapněte napájení.

Svítidlo upevněte pomocí hmoždinek a vrutů, použijte k upevnění oba krajní otvory, dle obr. A. 

Připojte modrý vodič na „N“, hnědý vodič na „L“ a žluto-zelený k zemnícímu vodiči. 

Nastavte svítidlo do požadovaného úhlu dle obr. B. 

McLED® záruka

McLED s. r. o. poskytuje záruku na LED svítidla v délce 3 roky.

V případě reklamace má odběratel právo na náhradu účelně vynaložených nákladů spojených s reklamací pouze v souvislosti 

s náklady na dopravu, která je předem odsouhlasena s prodávajícím. Pro posouzení oprávněnosti reklamace musí mít vždy 

výrobce možnost posouzení správnosti instalace LED svítidla a to přímo na místě instalace.

Dovozce: McLED s. r. o. , Vídeňská 185, 252 50 Vestec, tel.: +420 220 184 800, fax: +420 244 910 700, e-mail: [email protected], www.mcled.cz

Before you start installation

Installation Manual

Safety notes:

McLED® warranty

- In case of glass breaking, do not use the luminaire and ensure its replacement

- Important: Do not touch the luminaire during operation or shortly after turning 

off - risk of burning! Let the luminaire cool down! - Do not cover, place away from 

flammable substances

- Warning: Prevent contact of the luminaire internal parts with water

- Do not look at the luminaire from a short distance; there is a risk of injury to the eyes

- Do not dim! Under any circumstances, do not use in combination with dimming circuits

- Do not disassemble the luminaire - do not adjust or reset electronic 

components of the luminaire circuits.

- Installation and service may only be performed by qualified persons.

Installation dimensions (mm)

Installation

Mount the luminaire with dowels and screws. Use both lateral holes according to Fig. A. Adjust 
the luminaire to the desired angle to Fig. B.
Connect the blue wire to "N", brown wire to "L" and yellow-green wire to the 
grounding conductor. Check for correct connection and turn power on.

Unpack product and check it carefully
If the product is damaged in any way, submit your claim together with the product in 
its original packaging Please, do not use the damaged product
Do not connect the luminaire to the live mains

McLED s.r.o. (Ltd.) provides a three-year warranty on LED luminaires.
In case of a claim, the customer is entitled to compensation for costs associated with claims only in connection with shipping 

costs, which shall be approved by the seller in advance. To determine the legitimacy of the claim, the manufacturer must always 

have the option of assessing the correctness of the LED luminaire installation on the site where it is installed.

Importer: McLED s. r. o. , Vídeňská 185, 252 50 Vestec, tel.: +420 220 184 800, fax: +420 244 910 700, e-mail: [email protected], www.mcled.cz

Vor der Installation

Installationshandbuch

Sicherheitshinweise:

McLED® Garantie

- Beim Glasbruch den Leuchtkörper nicht verwenden und seinen Ersatz veranlassen

- wichtig: Leuchtkörper im Betrieb oder kurz nach dem Abschalten nicht berühren - 

Verbrennungsgefahr! Leuchtkörper abkühlen lassen! - nicht verdecken, außerhalb der 

Reichweite von brennbaren Stoffen anbringen

- Warnung: Kontakt der innenliegenden Teile des Leuchtkörpers mit Wasser vermeiden

- nicht in kleiner Entfernung in den Leuchtkörper blicken, drohende Augenschäden

- nicht dimmen! Nie mit dimmbaren Schaltkreisen verwenden

- Leuchtkörper nicht zerlegen - in die Einstellelemente elektronischer Schaltkreise des 

Leuchtkörpers nicht eingreifen und nicht verändern.

- Die Installation und Instandhaltung dürfen nur qualifizierte Personen durchführen.

Einbaumaße (mm)

Installation

Den Leuchtkörper mit Dübeln und Schrauben befestigen, zur Befestigung beide Randlöcher 
verwenden, siehe Abb. A. Den Leuchtkörper in gewünschten Winkel ausrichten, siehe Abb. B.
Das blaue Kabel an „N“, braune Kabel an „L“ und gelb-grünes Kabel an die Erdungsleitung 
anschließen. Auf richtigen Anschluss prüfen und Spannungsversorgung einschalten.

Das Produkt vorsichtig auspacken und überprüfen
Bei jeder festgestellten Produktbeschädigung ist das Produkt sofort in der 
Originalverpackung zu reklamieren. Versuchen Sie bitte nicht das beschädigte Produkt zu verwenden
Den Leuchtkörper nicht an das Stromnetz unter Spannung anschließen

McLED s. r. o. gewährt für die LED-Leuchtkörper eine Garantie von 3 Jahren.
Bei einer Beanstandung hat der Abnehmer das Recht auf den Ersatz der zweckmäßig aufgewendeten Kosten im Zusammenhang 

mit der Beanstandung betreffend lediglich die Transportkosten, die vorab mit dem Verkäufer abzustimmen sind. Zur Beurteilung 

der Legitimität der Beanstandung muss dem Hersteller immer die Möglichkeit gegeben werden, die Richtigkeit der Installation der 

LED-Leuchtkörper direkt vor Ort zu überprüfen.

Importer: McLED s. r. o. , Vídeňská 185, 252 50 Vestec, tel.: +420 220 184 800, fax: +420 244 910 700, e-mail: [email protected], www.mcled.cz

DELTA

DELTA

DELTA

2,1±0,3 kg

3,4±0,3 kg

4,5±0,3 kg

5,5±0,3 kg

8,3±0,3 kg

300x240x69

Size

Weight

Input Voltage

220-240 VAC

Working 

Temperature

Storing 

Temperature

-30°C +50°C

-40°C +70°C

50W

100W

150W

200W

300W

Product 

Specifications

335x295x71

375x320x75

400x345x78

464x410x83

2,1±0,3 kg

3,4±0,3 kg

4,5±0,3 kg

5,5±0,3 kg

8,3±0,3 kg

300x240x69

Size

Grosse

Eingangs-

spannung

220-240 VAC

Arbeiten 

Temperatur

Speicherung

Temperatur

-30°C +50°C

-40°C +70°C

50W

100W

150W

200W

300W

Produkt 

Spezifikationen

335x295x71

375x320x75

400x345x78

464x410x83

2,1±0,3 kg

3,4±0,3 kg

4,5±0,3 kg

5,5±0,3 kg

8,3±0,3 kg

300x240x69

Velikost

Váha

Vstupní napětí

220-240 VAC

Pracovní

teplota

Skladovací

teplota

-30°C +50°C

-40°C +70°C

50W

100W

150W

200W

300W

Technické 

údaje

335x295x71

375x320x75

400x345x78

464x410x83

17Nm

M10
2pcs

A

B

17Nm

M10
2pcs

A

B

17Nm

M10
2pcs

A

B

66

66

66

66

50.

000

h

50.

000

h

50.

000

h

50.

000

h

50.

000

h

50.

000

h

DELTA

17Nm

M10
2pcs

A

B

17Nm

M10
2pcs

A

B

17Nm

M10
2pcs

A

B

Reviews: