1/2
LG20 Change of display resolution (polarity)
Press
key of the axis you want to change and select
the measurement unit resolution.
When you have made your selection, press
key to save your settings.
Press key once while the display is .
The display will be (measurement unit resolution).
Press key to check the current measurement unit resolution.
LG20 Change of display resolution (polarity)
Ver.1 (2021.1) CS&S
* If you do not know the output resolution of the measurement unit, refer to the separate "Initial setup manual".
About 2 sec
For LG20-1, LG20-2, LG20-3
Press
key once to automatically switch to advanced settings mode.
The display will be
.
Press
key, the display becomes the normal display.
Display of measurement unit resolution (LG20-3)
Purpose of change
Operation
Explanation
Change the measurement unit resolution
Change the length measurement unit resolution in
the basic settings. And check the display resolution
in the detailed settings.
Change the display resolution
Change the display resolution in the detailed
settings
Change the display polarity
(Counting direction is reversed)
Change the display resolution in the detailed
settings
Diameter display (double count value)
Change to diameter display with display resolution
in the detailed settings
Detailed settings
⇒
Display resolution
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Diameter display
LG20-3
The operation method for changing the display resolution differs depending on the purpose and conditions of the change.
Select the purpose and conditions to be changed from the table below and perform the operation.
Basic settings
⇒
Measurement unit resolution
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Change polarity
Selection of measurement unit resolution
Set to basic setting mode.
Turn key “ON” while the AC adapter is energized.
Press and hold key for 3 seconds after the lamp changes from blinking to off.
Basic settings
⇒
Measurement unit resolution
⇒
Change
①
②
③
④
⑤
Switch from basic settings to normal count mode.
Press
key once and the display will change to
.
Press
key once and the display will change to
.
Input 1
Input 2
Input 3
Power ON
