WCK-3B-CC
WCK-6B-CC
Maximum Ratings: 30VDC, 200mA
Description
The WCK-3B-CC and WCK-6B-CC window covering
keypads are low-voltage contact closure devices that
interface with various shade controllers through their A/V
terminals. These keypads offer Raise, Lower, and Stop
functions of shades that are controlled by the
corresponding shade controller. The three button version
(WCK-3B-CC) is capable of interfacing to a single shade
controller. The six button version (WCK-6B-CC) can
interface to two separate shade controllers. These
keypads are low-voltage devices that are designed to fit
into a standard wallbox. The keypads are gangable with
Lutron
®
Claro
®
or Nova T
®
devices. Proper separation of
low-voltage and line voltage devices is required. Keypads
must be connected to shade controller using Class 2/
PELV wiring methods per the National Electrical Code.
Check with your local inspector for the code requirements
and wiring practices in your area. Lutron offers precision
product color matching.
Important Notes
1. Install in accordance with all applicable regulations.
2.
Do not connect high voltage power to device.
Improper wiring can result in personal injury or damage
to the device or to other equipment.
Cleaning Instructions
To clean keypad wipe with a clean damp cloth.
DO NOT
use any chemical cleaning solutions.
Installation
1. Turn OFF power feeding shade controller.
2. Run the control wire (4 conductor, 22-24 AWG) from
the shade controller to the wallbox for the keypad.
See Figure A or B.
3. Strip the insulation 1/2" from the wires.
4. Using the supplied wire connectors:
For a WCK-3B-CC or the lower section of a
WCK-6B-CC only:
• Connect the YELLOW wire to the wire going
to the Common terminal on the shade controller.
• Connect the GRAY wire to the wire going to the
Down terminal on the shade controller.
• Connect the BROWN wire to the wire going to the
Stop terminal on the shade controller.
• Connect the VIOLET wire to the wire going to the Up
terminal on the shade controller.
For a WCK-6B-CC upper section only:
• Connect the YELLOW/WHITE wire to the wire going
to the Common terminal on the shade controller.
• Connect the GRAY/WHITE wire to the wire going to
the Down terminal on the shade controller.
• Connect the BROWN/WHITE wire to the wire going
to the Stop terminal on the shade controller.
• Connect the VIOLET/WHITE wire to the wire going to
the Up terminal on the shade controller.
5. Using two screws, securely mount the keypad to the
wallbox. See Figure C.
6. Install wallplate (purchased separately).
7. Restore power feeding the shade controller(s).
Figure A - WCK-3B-CC Keypad wiring
Figure B - WCK-6B-CC Keypad wiring
Caution -
Do not over
tighten screws.
Figure C - Keypad mounting
DOWN
22-24 AWG wire
STOP
COMMON
BROWN
GRAY
YELLOW
G
N
D
D
W
N
U
P
SHADE
CONTROLLER
UP
VIOLET
S
T
P
Twist wire
connector tight.
Be sure no bare
wire is exposed.
DOWN
COMMON
STOP
YELLOW/WHITE
GRAY/WHITE
BROWN/WHITE
UP
VIOLET/WHITE
COMMON
STOP
YELLOW
GRAY
BROWN
UP
VIOLET
DOWN
G
N
D
U
P
D
W
N
SHADE
CONTROLLER
S
T
P
G
N
D
U
P
D
W
N
SHADE
CONTROLLER
S
T
P
22-24 AWG wire
Twist wire
connector tight.
Be sure no bare
wire is exposed.
Window Covering Keypad
Operating Instructions
Please Leave for Occupant
