www.Lumishore.com
Lumishore UK Unit 3, Technium 1, Kings Road, Swansea, SA1 8PH, UK | +44(0)208 144 1694 | [email protected]
Lumishore USA 7137 24TH Court East Sarasota, Florida 34234 | (941) 405-3302 | [email protected]
1
SY300 SUPRA DC Driver Installation Manual
Please read the following pages before attempting installation to ensure
complete understanding of the LUMISHORE SY300 SUPRA.
Before you start...
•
High Intensity LED light – Do not stare into the LED module at close proximity.
•
Always ensure that the vessel’s power source is disconnected or isolated prior to installation.
•
A qualified professional should carry out both the electrical and mechanical installation.
If in doubt please contact LUMISHORE. refer to product support section.
•
The Driver supplies voltage and current to the Underwater lights. Under no circumstances
should the light cable be cut and connected directly to voltage.
•
Always use a suitable fuse or circuit breaker to protect the complete system. Each light to be
individually fused.
•
Never try to install or remove light with the vessel in the water - Contact Lumishore for advice.
•
Lights should not be exposed to any temperatures in excess of 150°F (65°C). For example,
next to hot engine components or where exhaust emissions could be expelled onto the light
while underwater.
SY300 Light must be installed according to instructions 45-0082
45-0182-RevB
SY300 SUPRA DC Driver Installation Manual
