LINEAR INTERIOR SYSTEMS INC.
T. 905-265-0055 F. 905-265-0035 [email protected] www.linearinteriorsystems.com
T300 Series
INSTALLATION INSTRUCTIONS
PAGE 1
REPLACING AN EXISTING LOCK
(No door preparation Necessary)
INSTALL LATCH
ATTACH FACE PLATE
INSTALL STRIKE PLATE
INSTALL LOCKSET
Insert latch into the door edge and tap lightly into place. Turn latch tonge
according to strike handing, before installing face plate.
Insert latch into the door edge and tap lightly into place. Turn latch tonge
according to strike handing, before installing face plate.
Secure the latch strike to the jamb using wood strike screws provided.
If there is no strike prep, mark a centerline on the door jamb that aligns with the
centerline of the door latch. Drill one 1”(25mm) hole 5/8”(16mm) deep.
Use the D strike plate to make an outline on the door jamb and chisel 1/8”(3mm)
deep until it sits
fl
ush.
Drill two 1/8”(3mm) holes then secure strike with screws provided.
Insert Exterior Side (with two female threaded posts) guiding
the spindle into the latch.
Remove interior cover cap from the tabs provided.
Insert Interior Side guiding the spindle into the latch.
While holding together insert the two screws provided,
from interior side with guide holes provided and secure
the lockset to the door.
Clip on cover cap to conceal screws. Slip rose cover over lever
handle and guide into rose, and press to engage clip to secure.
A
A
B
B
C
C
D
E
D
TOOLS NEEDED
PHILLIPS
SCREWDRIVER
FLAT HEAD
SCREWDRIVER
1
2
3
4
PRIVACY PIN
PRIVACY PIN
