8
9
11 12 13
LP-TIMER-3
LINDGREN-PITMAN, INC.
q
Installation:
First locate your power source. The timer beeper should be
powered using
only clean12-24 volt DC power. Power should always come from a breaker that does not
exceed its maximum ratedamperage. The timer beeper draws approximately 1 amp at full load.
1. Hook Counter
3. Seconds
Between Hooks
9. Brightness
14. Timer Start Button
15. Timer Stop
2. Buoy Counter
4. Seconds
Between Buoys
7. Adjustment Keys
for Hook Timer
10. Adjustment
Keys for Buoy
Timer
Button
16
16
16
16
5. Hook Count Reset
6. Buoy Count Reset
Hook and Buoy Timer/Counter
Installation and Instruction Sheet
q
Mounting:
The enclosure is rated for a marine environment but care should be taken to place it
where it is not exposed to extreme weather or direct sunlight. It comes prewired so there should be no
need to openthe enclosure. Use the aluminum bracket attached to the back of the timer to preposition the
hole locations. Ifnecessary the bracket can be removed using a philips screwdriver. Once the holes are
located replace thebracket and mount the unit.
Only under extremely tight conditions should mounting without the bracket be attempted and
extra
special attention will be required or the unit will not operate
.
Remove the face of the unit by removing
the four philips screws that hold the face to the body (16).
Carefully
unplug the 8-pin terminal that
connects the membrane touch panel to the circuit board (the blue connector). If you are not careful the
ribbon cable will tear and the unit will not function. Do so by wiggling the connector from side to side while
pushing it towards the display.Please note the wire that attaches the touch panel to the circuit board is
short and can be easily damaged, do not pry or pull on it. You can also use a small screwdriver to push the
blue connector towards the displays until it unplugs from its mount on the circuit board. With the face
removed the base can be mounted using the holes located underneath the four philips screws that hold
the cover on the box (16). Use water-resistant marine grade 16 gauge tinned copper two conductor wire
or similar to connect the timer beeper to the power source and speaker. Once the mounting is complete
reconnect the 8-pin terminal strip to the unit and reinstall the four cover screws.
