A N G U S
MOUNTING INSTRUCTIONS
21619.000.000 Rev A
Included in the package:
• Angus unit (For units that
have an attached permanent
secondary unit, instructions
continue on the reverse side.)
• Drill template
• Hardware kit
1. Determine the desired location for the Angus unit underneath the
worksurface. Note that Angus must be placed at a minimum depth
of 4“ from the back edge
(Fig. 1)
.
2. Using a pencil, trace inside each of the four mounting holes onto
the mounting surface. Remove unit and drill pilot holes at the
locations just marked.
(Fig. 2)
.
3. Align Angus unit with the pilot holes, making sure to orient the unit
with the power switch facing the end user. Secure in place using
the provided screws
(Fig. 3)
.
4. Plug in the unit into an AC wall outlet.
Note: Do not plug Angus into
a power strip or extension cord.
5. Power Angus by turning on the switch. When the unit is “ON”, the
power switch will be lit.
F C C C O M P L I A N C E
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numériqué de la classe A est conformé à la norme NMB-003 du Canada.
Fig. 1
Tools required:
• Pencil
• Philips Head screwdriver
• Drill
• 1/8” drill Bit
4”
Fig. 3
Fig. 2
