Stepper drive with speed control DM2282-IO-24 easy manual
I/O Signals Connection
The I/O signals connections are as below, PUL signals indicate Start/Stop function, DIR signals indicate motor running direction, ENA
signals indicate lock the motor shaft (no need to be connected by default)
Control signals voltage is 24VDC.
DM2282-IO-24
2-phase Speed Control Stepper Drive
80-250VAC, 0.5-8.2A peak current, Auto-configuration, Low Noise
Motor Connection
DM2282-IO-24 can match with Leadshine 2-phase stepper motor, size include NEMA34, 42, 51
The motor connections are shown as below
4-lead Motor Connections
8-lead motor series connections
8-lead motor parallel connections
Features
External I/O signal control mode, with 24VDC
DIP switch setting drive’s output current and motor speed
PUL+ and PUL- signals indicate Start and Stop
DIR+ and DIR- signals indicate motor running direction
Alarm output, max 30Vdc / 100mA
Matched with NEMA 34, 42, 51 stepper motors
DM2282-IO-24 Interface
Power Supply Connection
Rang 80-250VAC, recommend L&N connect to
180-230VAC power supply, higher power voltage brings
better performance at high speed.
Recommend PE connect with the ground of equipment.
AC
AC
PE
Power Supply
Power Ether
Status Indicator
FAULT-
FAULT+
ENA-
ENA+
DIR-
DIR+
PUL-
PUL+
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
I/O signals
Motor Power
A-
Tuning Port
B+
B-
A+
DIP Switch
