background image

Wraps around

headrest

Wraps

around

seat

A  Bridge platform
B  Seat strap
C  Seat strap D-ring
D  Center console barrier
E  Headrest strap
F  Headrest strap D-ring
G  Cup holder
H  Barrier pocket      

Seat strap D-rings (C)

located on both colored sides

Installation:

1. Open the Backseat Bridge and lay it flat 

across the backseat of the vehicle with 
the preferred color facing up. Slide the 
bridge forward until the edge with the 
center console barrier is flush against 
the back of the front seats. Place on top 
of any front seat divider if needed, to 
ensure any gap between the platform 
and front seats is closed.

NOTE: The space between the back of the front seat and backseat 

edge should be 13” or less.

2. Secure seat strap (B) around the back rest of your driver’s seat, as close 

to the bottom of the seat as possible, and clip it to the seat strap D-ring 
(C). Repeat on your passenger’s side.

NOTE: Seat strap D-rings (C) are located on both sides of the bridge. 

Connect the seat straps to the D-rings located on the underside of 
the Backseat Bridge, based on your preferred color choice being 
right side up.

3. Pull headrest strap (E) around your driver’s side headrest and clip onto 

the headrest strap D-ring (F). Repeat this on the passenger side.

4. Adjust all straps for a secure fit.

Additional Tips

•   Continuous adjustment of the front seats may damage the bridge

•  The center console barrier (D) cannot hold up to sustained pressure. Please discourage your pup 

from resting their head, or putting their paws on the center console barrier (D).

NOTE:

 Space should 

be 13” or less

kurgo.com/product-instructions

5-15

Instructions and Care

Seat strap (B)

clips to the

D-ring (C) on

under-side

of platform

NOTICE: Please contact Kurgo directly with any product or warranty inquiries.

Kurgo Products  

• 

 2D Fanaras Drive, Salisbury, MA 01952  

  877-847-3868  

  www.kurgo.com  

  [email protected]

Our product cleaning instructions will help ensure that your gear has a long, exciting life. Washing by hand and hang air-drying is the best way to 

care for your Kurgo products.

Hand Wash Instructions

1. Brush off loose dirt with a dry brush.
2. Spot clean with a damp sponge, cold water, and 

mild soap.  Avoid harsh detergents.

3. If necessary, rinse larger area to eliminate 

excess soap residue.

4. Hang or lie flat to air dry (do not machine dry).

Cleaning Instructions

REAR SEAT

CONTAINMENT

REDUCES

DRIVER

DISTRACTION

These products prevent dogs from getting into the front seat where they can interfere with the driver and cause 

distracted driving accidents. They do this either as a physical barrier to the front seat or as a restraint to keep pets from 
roaming around in the car.

HARRISON SAYS…

Some dogs are overly excited to travel, making in and out of the car potentially dangerous. If they 
understand ‘stay’ this issue can be avoided. I suggest practicing on a leash; opening the car door 
and rehearsing ‘sit’ or ‘stay’ commands. Once stationary for a short time you can give your pup 
an assertive ‘OK’ command, letting him know it is safe to get in or get out. Make sure to always 
praise him when everything is done correctly.

Reviews: