KMC Controls Conquest HPO-9007 Series, Installation Manual

Page: 1 / 6

HPO-9007 Series Gateways Installation Guide 1 923-019-05B
HPO-9007 Series Gateways
Installation Guide
However, in practice, the maximum distance will
be substantially reduced by obstacles in the
path, the shape of the room, sources of radio
interference, and placement/orientation of the
sensors and gateway!
See the application guide Planning for Wireless
Sensors for important information about proper
placement of sensors and their gateway.
NOTE: KMC STW-6010 , STW-6014 , and
THW-1102 wireless sensors require
optimizing installation locations
for adequate RF range to the
gateway, adequate light for sensor
charging, AND accurate temperature
measurement. These factors may
require repositioning the gateway
from its original intended location to
optimize RF range to the sensors.
Testing operation before permanent
mounting is recommended. See the
sensors installation guide for more
information.
REMOVE BACKPLATE
1. Turn the hex screw clockwise into the
backplate until the screw clears the cover.
NOTE: The hex screw should remain in the
backplate.
INTRODUCTION
Complete the following steps to:
• Mount a KMC Conquest™ HPO-9007NW or HPO-
9007DW gateway
• Connect it to a KMC Conquest BAC-59xx/9xxx
controller
• Discover wireless sensors
NOTE: The HPO-9007s only receive signals
from sensors. They do not transmit
signals to devices.
NOTE: See the data sheet at kmccontrols.
com for specifications and other
information.
NOTICE
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE DEVICES
SELECT MOUNTING LOCATION
For the RF signal, the maximum theoretical
straight-line distance between the gateway
and sensors is about 100 feet (30 meters).
CONTENTS
Introduction .........................................................1
Select Mounting Location ......................................1
Remove Backplate ................................................1
Connect Ethernet Cable .........................................2
Install Cover ........................................................2
Configure ............................................................2
Software and Firmware Requirements ..................2
Convert and Configure the Sensor Object .............3
Add Sensors ....................................................3
Configure Value and Programming Objects ...........4
Use of HPO-9001 Distribution Module ......................5
Troubleshooting ...................................................5
Maintenance ........................................................6
Important Notices .................................................6
KMC Controls, 19476 Industrial Drive, New Paris, IN 46553 / 877.444.5622 / Fax: 574.831.5252 / www.kmccontrols.com