Page 1 of 2
Keystone Technologies • Philadelphia, PA • Phone (800) 464-2680 • www.keystonetech.com
Specifications subject to change. Last revised on 04.27.20
KTSL-FC1-UV-KO
BLUETOOTH WIRELESS FIXTURE CONTROLLER
INSTALLATION AND OPERATING INSTRUCTIONS
Read and understand all warnings and notes stated below before
proceeding with installation.
• Operating temperature: –40ºC/–40ºF to 45ºC/113ºF
• Do not use with enclosed metal luminaire.
• Do not expose directly to water.
• Not for outdoor use.
• Use only one controller per luminaire.
Warning:
Install/use in accordance with appropriate electrical codes and
regulations.
Warning:
If you are not sure about any part of these instructions, consult a
qualified electrician.
Warning:
Controlling a load in excess of the specified ratings will damage
the unit and pose risk of fire, electric shock, personal injury, or death. Check
your load ratings to determine the unit’s suitability for your application.
Warning:
To avoid fire, shock, or death, turn off power at circuit breaker or
fuse box and test to ensure that the power is off before wiring. Installation
without cutting power may also cause device malfunction.
Cautions:
• Disconnect power when servicing luminaire or changing bulbs.
• Use this device with copper or copper-clad wire only. With aluminum
wire, use devices marked CO/ALR or CU/AL only.
• Do not attempt to disassemble or repair.
• Clean outer surface with a damp cloth only.
INSTALLING
For 1/2" Knockout (KO) Installation
1. Remove the locknut on the 1/2" KO threading of the device.
2. Route wires and device threading through a 1/2" KO on fixture.
3. Place lock-nut over wires and screw onto threading to tighten controller
to fixture (see illustration to right).
4. Connect controller wires (see “Wiring” below).
For Screw Tab Installation
1. Position controller such that it is not fully enclosed by metal.
2. Secure controller into position with the screws appropriate for the
mounting surface.
3. Connect controller wires (see “Wiring” below).
Lock-nut
Fixture
Controller
WIRING
LED module
Bluetooth Wireless
Fixture Controller
10V+ (purple)
LED– (blue)
10V– (gray)
N (white)
Line (black)
L (black)
L1 (red/black)
LED+ (red)
Neutral (white)
LED Driver
