Let’s get
brewing.
Quick Start Guide
™
Before You Brew
Rinse & Fill
Remove the water reservoir lid, then lift the reservoir
straight up to remove it.
Rinse reservoir with fresh water and fill to the
MAX
fill
line.
Replace water reservoir, making sure the lock tabs
engage with the brewer. Replace lid.
NOTE:
Do not use distilled water.
Clean the Frother
Remove the lid and whisk from inside the frother.
Wash the interior of the frother, lid, and whisk with
warm, soapy water. Dry all parts thoroughly using a
soft, non-abrasive cloth, then reassemble.
NOTE:
Frother is not dishwasher safe. Do not submerge frother in water. Only
use non-abrasive cleaning materials to prevent damage to the inner surface of
the frother. Dry interior of frother and base with a soft cloth after cleaning.
Plug & Place
Remove packing tape from brewer and frother,
and plug into a grounded outlet. Lower the
frother base on the side of the brewer.
Place a large mug (10oz minimum) on the drip
tray.
Power On
Press power button - the green power light will
illuminate.
The brewer will automatically begin heating the
water. This will take about 4 minutes. Once the
heating sound stops, the brewer is ready.
Cleansing Brew
Lift and lower the handle.
Do not insert a K-Cup®
pod.
The three brew buttons and SHOT button
will blink.
Press the
6oz
button to start a cleansing brew.
Pour the hot water into the sink.
The one-time setup process is now complete
and you are ready to brew!
NOTE:
Between brew cycles, the brewer may take about a minute to reheat.
Add Water
10
8
6oz
SHOT
oz
oz
LATTE
6
oz
Add Water
10
8
6
oz
SHOT
oz
oz
LATTE
4
Add Water
10
8
6
oz
SHOT
oz
oz
LATTE
4
LID
WHISK
FROTHER
Add Water
10
8
6oz
SHOT
oz
oz
LATTE
Add Water
10
8
6oz
SHOT
oz
oz
LATTE
WARNING
!
RISK OF FIRE OR ELECTRIC
SHOCK DO NOT OPEN
WARNING, TO REDUCE THE RISK OF
FIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER SERVICEABLE PARTS INSIDE
1. WARNING: Keep all plastic bags away from
children.
2. CAUTION:
Keurig® recommends using only
Keurig® My K-Cup® Reusable Coffee Filter
and Keurig® approved K-Cup® pods in this
appliance. The use of non-Keurig® pods or
accessories may cause brewer malfunction or
injury.
3. CAUTION:
There are two sharp needles
that puncture the K-Cup® pod, one above
the K-Cup® pod holder and the other in the
bottom of the K-Cup® pod holder. To avoid risk
of injury, be aware of the needle locations.
4. CAUTION:
There is extremely hot water under
pressure in the K-Cup® pod holder during the
brew process. To avoid risk of injury do not
lift the handle or otherwise open the handle
during the brew process.
5. POWER CORD INSTRUCTIONS:
a. A short power-supply cord is provided to
reduce risks resulting from becoming entangled
in or tripping over a longer cord.
b. Longer detachable power-supply cords or
extension cords are available and may be used
if care is exercised in their use.
c. If a long detachable power-supply cord or
extension cord is used:
i. The marked electrical rating of the
detachable power-supply cord or extension
cord should be at least as great as the
electrical rating of the appliance.
ii. If the appliance is of the grounded type, the
extension cord should be a Grounding type
3-wire cord.
iii. The longer cord should be arranged so that
it will not drape over the counter top or table
top where it can be pulled on by children or
tripped over.
6. CAUTION: HOT COCOA/OTHER NON-
COFFEE PODS: Immediately after using a
hot cocoa/other non-coffee pod, run a hot
water brew cycle without a pod to avoid the
possibility of clogging the exit needle. DO NOT
assume the next user will do this.
1.
2. For household use only.
3. Do not use distilled water.
4. Scalding may occur if the handle is
opened during the brewing process.
5. Do not touch hot surfaces. Use handles or
knobs.
6. To protect against fire, electric shock, and
injury to persons do not immerse appliance,
cord, or plugs in water or other liquid.
7. Close supervision is necessary when any
appliance is used by or near children 12 years
or younger.
8. Unplug from outlet when not in use and
before cleaning. Allow to cool before putting
on or taking off parts, and before cleaning the
appliance.
9. Do not operate any appliance with a
damaged cord or plug or after the appliance
malfunctions, or has been damaged in any
manner. The appliance should be returned
to the nearest authorized service facility
for examination, repair, or adjustment if
applicable or contact Keurig customer service.
When using electrical appliances, basic safety precautions should always be followed,
including the following:
10. The use of accessory attachments not
authorized by the appliance manufacturer
may result in fire, electric shock, or injury to
persons.
11. Do not use outdoors.
12. Do not let cord hang over edge of table or
counter, or touch hot surfaces.
13. Do not place on or near a hot gas or electric
burner, or in a heated oven.
14. Always attach plug to appliance first (if not
permanently attached), then plug cord into the
wall outlet. To disconnect, turn any control to
″off″ then remove plug from wall outlet.
15. Do not use appliance for other than intended
use.
16. Use brewer in upright position only. Allow
brewer to cool (90 min) prior to turning it in
any position other than upright.
17. Do not immerse brewer in water.
18.
For detailed brewer cleaning and maintenance
instructions, videos, and the full Use & Care Guide
visit support.keurig.com.
