www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
CTD_F-7277_103018
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT TO
AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
INSTALLATION
1. To remove lens compress sides together as shown. See Figure 1.
2. Remove the screws that secure the LED bracket. See Figure 2.
3. Remove the LED assembly and disconnect the plug to the driver.
4. Store the LED assembly in a safe secure location.
5. Remove knock out from center of fixture or end plate.
6. Locate the housing on the grid and mark the mounting hole locations. See Figure 3.
7. Secure the fixture using user supplied hardware.
8. Connect the electrical service as indicated-
Black Wire - 120-277VAC or 347VAC
White Wire- Neutral
Copper Wire- Ground
9. Connect plug from LED assembly to driver.
10. Re-position LED assembly bracket and secure with screws previously removed.
11. Compress lens and secure to housing.
SERVICE
Driver Replacement
1. Confirm that AC power for all circvuits is disconnected before proceeding. Making LED connections on
energized circuits will damage LEDs.
2. To remove lens compress sides together as shown. See Figure 1.
3. Remove the screws that secure the LED bracket. See Figure 2.
4. Remove the LED assembly and disconnect the plug to the driver.
5. Store the LED assembly in a safe secure location.
6. Remove the nuts securing the driver and replace. See Figure 4.
7. Reinstall LED assembly and lens.
CTD SERIES
SIMPLESEAL
™
Luminaire for Sealed Enclosure Applications
