![background image](http://html1.mh-extra.com/html/enbrighten/49560/49560_manual_2405764001.webp)
49553, 49559, 49560, 49561, 49562 V2
12/15/19
FCC statement
Suppliers Declaration of Conformity | Model #: 49560 | Jasco Products Co., 10
E. Memorial Rd., Oklahoma City, OK 73114, www.byjasco.com
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1)
this device may not cause harmful interference,
and
(2)
this device must accept any interference received, including
interference that may cause undesired operation.
FCC NOTE:
The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: reorient or relocate the receiving antenna, increase the
separation between the equipment and receiver, or connect the equipment
into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION
BATTERIES MAY LEAK HARMFUL LIQUIDS OR
IGNITABLE MATERIALS OR EXPLODE CAUSING
INJURY OR PRODUCT DAMAGE.
• DO NOT MIX OLD AND NEW OR OTHER
BATTERY TYPES
• REPLACE ALL BATTERIES AT THE SAME TIME
• REPLACE FULLY DISCHARGED BATTERIES
IMMEDIATELY
• REMOVE BATTERIES IF PRODUCT IS TO
BE UNUSED FOR EXTENDED PERIOD OF TIME
LED Mini Lantern
The lantern is operated with 4 AA batteries (not included). Batteries must be installed or replaced in sets of
four.
NOTE: If replacing the batteries, remove the old batteries and follow the instructions below.
• Do not attempt to hang lantern with handle in open position.
• Always be sure to hang the lantern in a safe and secure area.
• Lantern should never be left out in excessive wind.
Battery Installation:
Using the latching handle:
1. Turn the lantern over and remove
the battery cover by twisting the
cap counterclockwise.
2. To operate the lantern using
4 AA batteries, install noting
proper battery polarity.
3. Replace the battery cover by
fitting the center plastic column
within the base and then twisting
the cover clockwise until it clicks
firmly into place.
1. To open the handle, depress the
raised button near the bottom of
the handle.
2. Fully open the handle. Close
handle around object you wish
the lantern to hang from.
3. Be sure the handle is securely
latched before allowing lantern
to fully hang on its own.
MADE IN CHINA
Distributed by Jasco Products
Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a
5-year limited warranty. Visit
www.byjasco.com for details.
Questions? Contact us at
1-800-654-8483 between 7AM-8PM,
M-F, Central Time.
enbrighten
®
enbrighten
®
100%
recyclable
Separate
paper
from plastic
before
recycling
byjasco.com/recycle
paper made from 25%
post consumer waste
READ IT
OR
WATCH IT
Read instructions or watch
easy-to-follow video. Scan QR code
or visit http://bit.ly/351NYMk