www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United States with more than 50% of the component cost of US origin. It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
EPC_F-4492_08318
Luminaires for Food Processing Applications
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND
THE HAZARDS INVOLVED. DISCONNECT POWER TO ALL CIRCUITS
BEFORE WIRING FIXTURE. INSTALL IN ACCORDANCE WITH
ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT CONNECT
TO AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS
AND LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE.
SUPPLEMENTAL INSTRUCTIONS MAY BE LOCATED ON THE
FIXTURE, IN ADDITION TO THIS INSTRUCTION SHEET, REGARDING
ORIENTATION, OR MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS
OVERVIEW
EPC SERIES
ENVIROPRO
™
EPC Series fixtures are designed to be suspended, pendant or surface mounted. Supplied stainless steel mounting
straps are fully adjustable along the length and provide 90 degree (45 degrees each side) rotational aiming.
Fixtures are pre-wired with a 72" oil and water resistant outdoor cable. Connection to electrical service must be
made using approved water tight connector or plug and receptacle.
SUSPENDED MOUNTING
Installation
1:
Remove spade screw, washer and sealing washer.
Remove the end cap from the end without the
cable.
2:
Remove the tube and install lamps.
3:
Replace the tube and end cap. Replace the sealing
washer, washer and secure by tightening the spade
screw.
4:
Wrap the two supplied stainless steel straps around
the tube and secure by pulling the tab to lock into
the slot on the other side.
5:
Hang the fixture by attaching to user supplied chain
or cables. Adjust the mounting straps along the
length of the fixture as needed.
6:
Connect the cable to the appropriate electrical
service. Black wire to supply, white wire to neutral
and green wire to ground.
