InSync
®
I Installation Instructions
Pg. 1 of 2
InSync
®
I
Installation Instructions
All parts needed to install the InSync
®
I lock are included with each unit. Check to make sure all parts are
accounted for before beginning installation. Do not substitute any of the parts. The use of substitute parts
will result in poor performance of the lock.
1. Prepare the door using the InSync I installation
template.
2. Prepare the door frame using the template and
install the strike plates using the screws
provided.
3. Install the dead bolt and latch bolt in the door
edge and fasten them to the door with the
screws provided (see Fig. 3).
4. Determine the hand of the door (see Fig. 1).
With the dead bolt extended, properly orient
the tailpiece (see Fig. 2). Install the upper outside trim,
keeping the battery wire above the dead bolt.
Feed the tailpiece through the dead bolt hub and
hold the trim against door.
Fig. 1
Tailpiece
Important:
Rotate the tailpiece and retract dead
bolt to confirm proper alignment with the door
frame.
5. Before installing the inner trim, rotate the lever to
insure that the tailpiece cam is in the correct
orientation (see Fig. 3, Detail “A”). Verify that the
dead bolt is retracted and the upper outside trim
is in place. While placing the inner trim in
position, feed the wire harness through the
appropriate hole in the inner chassis and attach
it with the two 1/4-20 machine screws.
Fig. 2
All information contained herein, including but not limited to product pricing and other intellectual property, is confidential and
intended for the sole use of the addressee(s) so named. Any misuse of this confidential information contained herein may result in
legal action by Computerized Security Systems dba SAFLOK and its parent company.
© SAFLOK™
WL 4/23/2008
